HEGNER LKH 950 Duplicator Manual

':i.i i.l ,
''::; ,... :
-2
Aliqnment of Cutter
Cutter is factory aligned.
.u"i:g supptied If cutter
gruge (p""i
has moved, align.cutter
6)
oy trghtening as shown byr
hex screws.
in diagram. S""u""-"rtir"
Duplicatinq from a Turninq
Place the turning you rrvish
the rear
to duplicate
of between
the, iupii""io; the two centers
i;; may have
at
to accomodate the i"ngih-or'iiJ
to reposition pr""e one center
the blank. position you are dupricating). Mount
at "6rr", fp".t rz j-o,r-irp'ii"lt""
the s m a I l e s t---oilJ"tu","r so that it rests
wheel (part 9) counLe."fo"lriue,unti]
tn""[i""- t" be copied. cutter (part Turn
far enough from br.ank;;-il;t;lank B) is retracted
and lower cutter, can by. tu"n ile"ry. Turn on rathe
starts to cut inro btank.
lu"ninf-rnJur
d"il;,1o (p;;f gi"i""p,rse untit eutter
at a time, eaeh time movi"g-irpri"gtiil iurn;;;;"?;"rr ?) r/2
;;;;"'ltong. Lo2 rurns
of turning bv means of J.ari"-"[or."o;#"i-;;'ir,, entire rensrh
until vou reach tne oesir"i-oi5r"ter r";nt of the
in
iathe,
to turn more than
In"-r"llpiece.
one dupricate If you
of the ;; ;;., need
and set the dupli:,"tol d;il-;;uq" (p""i-iol"""-rhat
turn rathe off
part lr' Lock depth aa;ustmenE-i;to it rouehes
No' bosition ji
r5) ' The duori""t;;-;;"'io, tignt"ning nut (part
additional blanls "orr"ted
properiy
to identical to dupricate
drameters.
Duplicatinq from a Template
Remove centers for^holding turnings o! duplicator. and mount tempJ-ate
ho'Lders instead'- see oi"g""r'fo" rn*irum'and minimum dimensions
arlowed for temo-r"t"' --ri;il"'tempiaiu"in"i'Jrpr.te horders by
tightenins screws' I*grii"i:rot"i"-n"ii"""""!""pt remprates up ro
i" *;ff:"ffJ.:::. o,piii"i;;-;"
Sharpenino of Cutter
IHPORTANI: Angle of cutter
required, but only from the
the angle of the cutter.
must
be altered. Sharpen
INNERnot
surface,
cutter when
taking care not to alter