Broadcom NetXtreme Ethernet Adapter Diagnostic User's Guide ...
Broadcom NetXtreme Ethernet Adapter Diagnostic User's Guide ...
Broadcom NetXtreme Ethernet Adapter Diagnostic User's Guide ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Broadcom</strong> <strong>NetXtreme</strong> <strong>Ethernet</strong> <strong>Adapter</strong> • <strong>Diagnostic</strong> User’s <strong>Guide</strong><br />
6 User Interface Commands<br />
The commands are summarized in twelve groups: vpd, seeprom, cpu, dma, packet, mii, mem, test,<br />
power, irq, mac, and misc.<br />
Command Group vpd<br />
vpdwrite Write VPD Memory<br />
vpdread Read VPD Memory<br />
Command Group seeprom<br />
semode Set SEEPROM Mode to Manual or Auto Mode<br />
seread Read SEPPROM<br />
sewrite Write SEPPROM<br />
secfg Configure SEEPROM<br />
seprg Program SEPPROM<br />
sever Display Serial EEPROM Version<br />
sechksum Check/Update Serial EEPROM checksum<br />
Command Group cpu<br />
cpudtt Dump Debuging Trace of TX CPU<br />
cpudrt Dump Debuggin Trace of RX CPU<br />
Command Group dma<br />
dmaw DMA from NIC to Host Memory<br />
dmar DMA from Host to NIC Memory<br />
dma_h Dump DMA Entries<br />
dma_d Dump DMA Entries with Decode<br />
Command Group packet<br />
maclpk Configure MAC loopback<br />
nicstats Display NIC statistics<br />
ringindex Dump Ring Index<br />
blast Blast Packts in Poll Mode<br />
tprot Blast with TPROT packets<br />
txpkt Transmit Packet<br />
phyctrl Configure Speeds/Duplex Mode<br />
statusblk Dump Statistics Block<br />
reset Reset Chip<br />
txcfg Configure protocal packets for transmission<br />
rxcfg Configure Rx parameters<br />
Command Group mii<br />
mread Read PHY register via MII<br />
mwrite Write PHY registers via MII<br />
page 21<br />
<strong>Broadcom</strong> Confidential and Proprietary
Change language