Operating instructions Wire feed unit - EWM Hightec Welding GmbH
Operating instructions Wire feed unit - EWM Hightec Welding GmbH
Operating instructions Wire feed unit - EWM Hightec Welding GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Design and function<br />
MIG/MAG welding<br />
5.7.10.2 MIG/MAG overview of parameters, M3.70<br />
Figure 5-13<br />
Basic Parameters<br />
Item Meaning / Explanation Setting Range<br />
1 Gas pre-flow time 0.0s to 20.0s<br />
2 P START<br />
<strong>Wire</strong> speed, relative<br />
Arc length correction<br />
1% to 200%<br />
-9.9V to +9.9V<br />
3 Duration 0.0s to 20.0s<br />
4 Slope duration from P START to P A 0.0s to 20.0s<br />
5 P A<br />
<strong>Wire</strong> speed, absolute<br />
6 Dynamics -40 to +40<br />
0.1 m/min to 40 m/min<br />
7 Duration (spot time and superpulse) 0.01s to 20.0s<br />
8 P B<br />
<strong>Wire</strong> speed, relative<br />
Arc length correction, relative<br />
1% to 200%<br />
-9.9V to +9.9V<br />
9 Duration 0.01s to 20.0s<br />
10 Slope duration from P A to P END 0.0s to 20s<br />
11 P END<br />
<strong>Wire</strong> speed, relative<br />
Arc length correction<br />
1% to 200%<br />
-9.9V to +9.9V<br />
12 Duration (superpulse) 0.0s to 20s<br />
13 Gas post-flow time 0.0s to 20s<br />
14 Superpulses On / Off<br />
46<br />
099-004846-EW501<br />
8.01.2014