NV-B601NV-B604NV-B605 5 in1 Diamond Dermabrasion ... - Nyt Smil

System Details 10
To use the Diamond Dermabrasion function:
1. Connect all associated components:
a. Unscrew the Diamond Vacuum Output socket and ensure a large cotton filter is in the center
and a large black ring is around connector head.
b. Replace the Diamond Vacuum Output socket.
c. Attach one end of the PVC hose to the Diamond Vacuum Output socket.
d. Attach the other end of the PVC hose to the end of the diamond-tipped wand.
e. Ensure a small black ring is around the head of the wand.
f. Place a small cotton filter on the head of wand.
g. Select the appropriate diamond tip size and screw it into the wand. If necessary, refer to Table
1 for recommended diamond tip usage.
2. Connect the plug to the Power Cord connector, plug in, and press the power button.
3. Turn the Vacuum Intensity Knob to the lowest setting.
4. Slowly increase the vacuum intensity to the desired setting (see Table 1 for recommendations). The
Vacuum Meter will display the amount of pressure. In general, the maximum vacuum intensity should
only be used when necessary.
Table 2: Recommended Vacuum Intensity Settings
Treatment Normal Skin (inHg) Sensitive Skin (inHg)
Area
Face 12-22 8-12
Forehead 12-22 10-12
Chest 15-20 15-18
Nose 10-15 10-14
Neck 18-18 10-15
Near Eye Area 8-12 8-10
5. Using a slow sliding motion, move the diamond tipped wand across the skin. Refer to the “Treatment”
section of Chapter 3 of this guide for details about how to use the system to treat specific areas of the
face and body. Important: Do not leave the diamond tip in one area for an extended period of time.
Doing so may damage to the skin.
6. Using your thumb and finger, gently stretch the skin of the treatment area and glide the wand two or
three more times over the area. Note: Crisscrossing your movements is recommended to prevent
streaking. You may use brush strokes or polishing motions in different areas of the skin being treated.
7. When the treatment is complete, use a soft brush to remove any dead skin and rinse the treated area
with a damp sponge or a cool, damp towel.
8. Allow the skin to dry and then apply desired skin product.
9. Use a toothbrush or cotton swab dabbed in alcohol to clean the diamond tip.
10. Sterilize diamond tip with ultraviolet light or high temperature.
NV-B601NV-B604NV-B605 5 in1 Diamond Dermabrasion System