Hinged Half Round Glass Trap Door - Spiral Cellars
Hinged Half Round Glass Trap Door - Spiral Cellars
Hinged Half Round Glass Trap Door - Spiral Cellars
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Hinged</strong> <strong>Half</strong> <strong>Round</strong><br />
<strong>Glass</strong> <strong>Trap</strong> <strong>Door</strong><br />
DATA SHEET<br />
White <strong>Spiral</strong> Cellar<br />
n Length 1478mm<br />
n Width 996mm<br />
n Internal opening 1430mm x 865mm<br />
n Material Stainless Steel – Satin polished to 240 grit<br />
Original <strong>Spiral</strong> Cellar<br />
FRAME<br />
n Length 1358mm<br />
n Width 996mm<br />
n Internal opening 1300mm x 830mm<br />
n Material Stainless Steel – Satin polished to 240 grit<br />
DOOR<br />
n <strong>Glass</strong> 2 layers of 10mm toughened glass with 1.5mm laminate.<br />
n Trim 1.5mm stainless steel flat trim.<br />
n Hinges 2 hinge plates set level with top of frame. 50mm deep.<br />
n 16mm Bronze pivot pin inserted through hinge plate.<br />
From underside of frame to top of trim = 40mm.<br />
n Linak actuator motor 12V with a thrust of up to 2500N.<br />
OVERALL HEIGHT<br />
LIFTING MECHANISM<br />
n Motor is fixed to a stainless steel back plate, onto top rings of cellar, and connected to a control box which sits within a top<br />
cellar module.<br />
n Arm of motor is fixed through two holes to centre steel trim of door. Two recessed hex head machine screws hold the arm in place.<br />
Removal of these two screws (from the topside of door) will release the motor arm in case of failure.<br />
n A manual gas strut arm is also fixed from stainless steel back plate to centre steel trim of door.<br />
n <strong>Door</strong> takes 26 seconds to open to 85 degrees maximum.<br />
n Duty cycle: Max 10% or 2 minutes continuous use followed by 18 idle minutes.<br />
n Ambient operating temperature of motor: from 5ºC to 40ºC.<br />
n Motor has protection class IP51.<br />
n Motor approved to: EN 60601‐1/UL 60601‐1 in connection with CB8, CB12, CB14, CB18 AND CBJ.<br />
n <strong>Door</strong> is operated by switch on nearest wall.<br />
SC_TDDS_<strong>Hinged</strong> <strong>Half</strong> <strong>Round</strong> <strong>Glass</strong> <strong>Trap</strong><br />
<strong>Door</strong>/issued date 2012/06/27/Issued by NA/<br />
Version 1.0<br />
www.spiralcellars.com
<strong>Hinged</strong> <strong>Half</strong> <strong>Round</strong><br />
<strong>Glass</strong> <strong>Trap</strong> <strong>Door</strong><br />
DATA SHEET<br />
FFL<br />
Flooring<br />
Hinge block<br />
<strong>Door</strong><br />
13 12<br />
50<br />
70<br />
Frame<br />
Hinge block<br />
Hinge pin<br />
Flooring<br />
<strong>Door</strong> Trim<br />
SC_TDDS_<strong>Hinged</strong> <strong>Half</strong> <strong>Round</strong> <strong>Glass</strong> <strong>Trap</strong><br />
<strong>Door</strong>/issued date 2012/06/27/Issued by NA/<br />
Version 1.0<br />
www.spiralcellars.com