to download PDF file - Bradford White

More documents

Recommendations

Info

COMMERCIAL GAS MODELS LIGHT DUTY POWER DIRECT VENT Light Duty Power Direct Vent models are the solution for installations that lack sufficient combustion air or where an outside wall for ventilation is not readily accessible. All models can vent vertically or horizontally and are also approved for unbalanced, direct-vent closed combustion applications. Unbalanced venting means the air intake pipe doesn't have to be vented on the same external building surface as the exhaust vent. Light Duty Power Direct Vent models are also available in Ultra Low NOx Eco-Defender Safety System ® versions. APPLICATIONS: Office buildings, small apartments, and motels FEATURES: full descriptions are available in glossary beginning on page 33 INTAKE/ COMBUSTION AIR VENT EXHAUST Concentric Vent Terminal Kit 36 1 /4" RAIN CAP P/N 239-44069-01 (When using the Concentric Vent Terminal the maximum vent length is reduced by 10ft.) • ICON System Control • ICON System Accessory Package Compatible • OnGuard RMT System Compatible– Accessory Module Required • Defender Safety System ® • Electronic Ignition • Closed Combustion Venting System • Powerful Blower Motor • Horizontal and Vertical Venting • Optional Concentric Vent Terminal Kit • Hydrojet ® Total Performance System • Vitraglas ® Lining Model Number PDX-50S-60FB-3N PDX-65S-65FB-3N PDX-75S-70FB-3N Capacity Input Recovery at 100°F Rise* Nat. LP Nat. LP U.S. U.S. BTU/Hr. BTU/Hr. GPH GPH U.S. Gal. 48 65 75 60,000 65,000 70,000 60,000 60,000 65,000 • Max Temp - 180˚F • NSF Construction Available • ¾” NPT Dielectric Waterway Fittings • Side Connections • Protective Magnesium Anode Rod • Low Restriction Brass Drain Valve • T&P Relief Valve Installed • 2" Non-CFC Foam Insulation • 3–Year Limited Tank Warranty– can be upgraded to 5–Year at additional cost Floor to Exhaust Vent Approx. Shipping Weight These models are not recommended for sanitation purposes. For LP Gas models, replace the suffix "B" with "S" and change the "N" to "X". (ExamplePDX-50S-60FS-3X ) *Based on manufacturers rated recovery efficiency. Venting Dimensions 3" Vent Pipe Max. Intake Length Max. Exhaust Length Min. Vent Length Number 1 of 2 90° Elbows† 3 PDX-50S PDX-65S 60 ft. 60 ft. 7 ft. 55 ft. 50 ft. 45 ft. PDX-75S 50ft. 50ft. 7ft. 45ft 40ft 35ft. 58 63 68 58 58 63 4" Vent Pipe in. 68 71 1 /4 71 Max. Intake Length Max. Exhaust Length Min. Vent Length Number 1 of 2 90° Elbows† 3 Jacket Dia. in. 22 24 26 PDX-50S PDX-65S 100 ft. 100 ft. 7 ft. 95 ft. 90 ft. 85 ft. Vent Size in. 3 3 3 PDX-75S 90ft. 90ft. 7ft. 85ft. 80ft. 75ft. lbs. 303 330 375 Subtract 5ft. for each additional 90° elbow. †Consult I&O Manual when using four or more elbows. 10 QUESTIONS SPEAK WITH OUR EXPERTS AT 800.523.2931
EVERHOT ® AND EVERHOT ® HE CONDENSING TANKLESS These tankless gas models offer the temperature, output and BTU/Hr. ranges to meet almost any demand for hot water. Stand-by heat loss is eliminated for optimal energy savings and the option to mount these units indoors and outdoors saves premium floor and room space. They offer variable, digital control of the water temperature while monitoring and maintaining efficiency. They can be manifolded together to serve even higher demands. APPLICATIONS: Small restaurants and office buildings FEATURES: full descriptions are available in glossary beginning on page 33 • Integrated Primary Control (Indoor) • Remote Primary Control Included (Outdoor) • A Commercial Controller (p/n 239- 47805-00 for TG) and (p/n 239-48789- 00 for TGHE) is Required for Commercial Applications • 96°-185°F Temperature Range • Indoor or Outdoor Installation • Natural Gas or Propane Gas • Freeze Protection to -30˚F • ¾” NPT Dielectric Waterway Fittings • Limited 5–Year Warranty on Heat Exchanger and Parts EverHot ® Model Number TG-150I-N TG-150E-N TG-180I-N TG-180E-N TG-199I-N TG-199E-N OPTIONAL FEATURES • All Venting is Optional (Must be ordered as separate line item product) • Standard Horizontal or Vertical Venting Kits are Available • Roof Flashing Assembly for Flat or Pitched Roofs • Condensate Collector • Pipe-cover Enclosure • Indoor Models are Available with Vertical or Horizontal Discharge Adapters • Recessed Wall Box Available Installation Input Minimum Maximum Maximum Hot Water Capacity Rise 35°F 65°F 100°F Height Width Depth Approx. Shipping Weight Nat. BTU/Hr. GPM in. in. in. lbs. Indoor Outdoor Indoor Outdoor Indoor Outdoor 15,000-150,000 15,000-150,000 15,000-180,000 15,000-180,000 15,000-199,000 15,000-199,000 Check local codes if installation is for sanitation purposes. 5.0 5.0 7.5 7.5 9.4 9.4 4.2 4.2 4.6 4.6 5.0 5.0 2.5 2.5 3.0 3.0 3.3 3.3 23 20 23 23 23 23 14 14 14 14 14 14 9 1 /2 7 9 1 /2 10 9 1 /2 10 50 37 50 46 50 46 (TG-199I-N, TG-199E-N, TGHE-160I-N, TGHE-160E-N, TGHE-199I-N & TGHE-199E-N) EverHot ® HE Condensing Model Number TGHE-160I-N TGHE-160E-N TGHE-199I-N TGHE-199E-N Installation Indoor Outdoor Indoor Outdoor Input Minimum Maximum Nat. BTU/Hr. 9,500-157,000 9,500-157,000 9,500-199,000 9,500-199,000 Maximum Hot Water Capacity Rise 35°F 65°F 100°F GPM 8.0 8.0 9.8 9.8 4.6 4.6 5.8 5.8 3.0 3.0 3.8 3.8 Height in. 26 13 /32 26 13 /32 26 13 /32 26 13 /32 Width in. 18 1 /2 18 1 /2 18 1 /2 18 1 /2 Depth in. 10 7 /64 10 7 /64 10 7 /64 10 7 /64 Approx. Shipping Weight lbs. 64 64 71 71 Check local codes if installation is for sanitation purposes. For Propane (LP) Models change suffix "N" to "X". (ExampleTG-150I-X ) Requires AC 120 Volts - 60 Hz. Indoor models supplied with a 120 Volt power cord. VISIT WWW.BRADFORDWHITE.COM FOR THE RIGHTSPEC ® SIZING AND CROSS REFERENCE PROGRAM. 11
Page 1 and 2: MADE IN AMERICA
Page 3 and 4: COMMERCIAL GAS MODELS Light Duty At
Page 5 and 6: D RESOURCES Eco-Defender Safety Sys
Page 7 and 8: LIGHT DUTY ATMOSPHERIC VENT HIGH IN
Page 9 and 10: LIGHT DUTY TTW ® HIGH PERFORMANCE
Page 11: LIGHT DUTY HIGH INPUT DIRECT VENT L
Page 15 and 16: A S ME ASME & NON-ASME MILLIVOLT AS
Page 17 and 18: A S ME ASME & NON-ASME POWER DIRECT
Page 19 and 20: A S ME ASME & NON-ASME ELECTRONIC I
Page 21 and 22: TRIFLEX 3-ELEMENT MEDIUM DUTY The T
Page 23 and 24: A S ME ASME IMMERSION THERMOSTATS W
Page 25 and 26: DAIRY BARN This specialized product
Page 27 and 28: COMMERCIAL OIL MODELS CENTER AND RE
Page 29 and 30: COMMERCIAL INDIRECT MODELS POWERSTO
Page 31 and 32: COMMERCIAL STORAGE TANKS SMALL VOLU
Page 33 and 34: A S ME VITRAGLAS ® COATED UNJACKET
Page 35 and 36: GLOSSARY OF ITEMS/FEATURES Accessor
Page 37 and 38: fault alert notification, authorize
Page 39 and 40: Get 25 FREE Bonus Points for Signin

to download PDF file - Bradford White

Create successful ePaper yourself

Delete template?

Save as template?