CAVITY WALL TIES - mkm.strawberryadm...

More documents

Recommendations

Info

Staifix Timber Frame Tie (Type 6 Tie) for fixing masonry to timber frames To Suit Cavities (mm) 50, 75, 100 Application Cavity wall tie for use in the construction of timber-framed buildings up to 4 storeys in height. Supplied complete with an annular ring shank nail. CRANKED, TO EASE INSTALLATION 10
Installation 1 Position the tie on fresh mortar in the bed joint of the outer leaf of masonry with the upstand against the timber. 2 Hammer the nail, through the hole in the upstand, into the timber framework. 3 Build the tie into the bed joint of the new masonry ensuring it is surrounded by mortar. Density of Timber Frame Ties Timber Frame Ties should be installed at a density of 4.4 ties per square metre in buildings where the basic wind speed does not exceed 25m/s (BS6399-2: 1997 Code of Practice for Wind Loads). The density should be increased to 7 ties per square metre in more severe situations. 11
Page 1 and 2: CAVITY WALL TIES for traditional br
Page 3 and 4: Cavity Wall Ties for traditional br
Page 5 and 6: Density and Positioning of Ties Typ
Page 7 and 8: Ancon ST1 Heavy Duty Tie (Type 1 Ti
Page 9: Staifix Starter Tie Installation 1
Page 13 and 14: Staifix-Thor Helical Crack Stitchin
Page 15 and 16: Helical Nails for Pitched Roofs Eur
Page 17 and 18: Helical Nails for Flat Roofs Super-
Page 20: GREAT PRODUCTS. GREAT SERVICE. GREA

CAVITY WALL TIES - mkm.strawberryadm...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?