HRAM Balloon Attachment and Removal ... - Sandhill Scientific
HRAM Balloon Attachment and Removal ... - Sandhill Scientific
HRAM Balloon Attachment and Removal ... - Sandhill Scientific
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
High Resolution Anorectal<br />
Manometry <strong>Balloon</strong><br />
<strong>Attachment</strong> Instructions<br />
Using Polyurethane B<strong>and</strong>s<br />
(Part # A86-4100)<br />
High Resolution Anorectal<br />
Manometry <strong>Balloon</strong><br />
REMOVAL Instructions<br />
Using Polyurethane B<strong>and</strong>s<br />
(Part # A86-4100)<br />
7 1<br />
7. Squeeze the h<strong>and</strong>le of the ligator to release the<br />
b<strong>and</strong> onto the probe. Check to make sure the<br />
b<strong>and</strong> is aligned properly in the groove.<br />
1. Gather equipment: Suture <strong>Removal</strong> Scissors <strong>and</strong><br />
Forceps<br />
2<br />
8<br />
Tie-on B<br />
2. Gently stabilize b<strong>and</strong> with forceps taking care not<br />
to apply pressure to the sensors.<br />
8. Slide the tip of the balloon down so that tie-on B<br />
is visible in the nipple at the end of the stimulation<br />
balloon<br />
3<br />
9<br />
3. Slide suture removal scissors under each b<strong>and</strong><br />
<strong>and</strong> cut. Remove balloon from probe <strong>and</strong> discard<br />
balloon.<br />
9. In the same manner as for tie-on A, attach a b<strong>and</strong><br />
onto the probe at tie-on B.<br />
S<strong>and</strong>hill <strong>Scientific</strong>, Inc<br />
9150 Commerce Center Circle, #500<br />
Highl<strong>and</strong>s Ranch, CO 80129 USA<br />
800.468.4556 303.470.7020<br />
Fax: 303.470.2975<br />
PM-11-002, Rev 1.1
Change language