Official Rule Book - Lucas Oil Regional Off Road Racing

D. Sternum straps are not allowed.
E. At any place the lap belt, harness, or crotch belt passes over any substance that could cause
cutting of the belt, the belt must be rolled, padded, or have a grommet installed.
F. All seat belts and shoulder harnesses must connect at the lap belt with a quick release
buckle.
G. Seat belts must be certified to SFI specs 16.1 or 16.5 and dated by the manufacturer. Belts
must not be used beyond two years after stated date.
H. Seat belts may be rejected by LORORS officials if dirty, frayed, oily, greasy, or otherwise
considered unsafe by officials.
SR-7 Arm Restraints
A. Arm restraints are mandatory in the RZR XP class. Restraints must be certified to SFI spec
3.3 and clearly labeled.
SR-8 Head and Neck Restraints
A. Head and neck restraints are mandatory in all classes any time the vehicle is on the track.
1. Head and neck restraints must be certified to SFI spec 38.1 with a legible sticker
attached.
2. The head and neck restraint, when connected, must be mounted, configured,
maintained and used in accordance with the manufacturer’s instructions.
3. It is the responsibility of the driver to ensure that his/her restraint is correctly installed,
maintained, and properly used.
SR-9
Gas Pedals
A. All purpose-built vehicles must have a flat full support gas pedal with a toe hook. This is
highly recommended in the stock classes as well.
B. Toe hook must enable the driver to pull back on the pedal with foot in the event of a stuck
throttle.
SR-10 Roll Bars
A. Chromoly or D.O.M. is required for the basic roll cage and must be LORORS approved.
Aluminum and/or soft metals are not allowed. Roll bar construction must be welded.
B. Specific size and wall thickness of roll bars is addressed in race division rules and outlined in
included diagrams.
C. Roll bar padding is required on all bars that may come in contact with driver. Padding must
be firmly attached so it cannot rotate or move.
SR-11 Windshield Area
A. Trucks & UTVs must have complete left half of windshield opening covered with a LORORS
approved rock guard. Buggies must have complete windshield opening covered with a
LORORS approved rock guard.
B. Rock guard must have a minimum 1/8 inch rod and a maximum 1.5 inch square opening
welded at each intersection.
C. If a passenger is in vehicle, rock guard must cover full windshield opening.
12