Official Rule Book - Lucas Oil Regional Off Road Racing

A. A performance clutch may be used to increase durability.
FS-24 Transmission
A. A ¼ inch thick steel bell housing shield is required on manual transmission trucks. The shield
must cover the top 180 degrees of the bell housing.
B. On automatic transmission trucks, a transmission shield or blanket must cover the top 180
degrees of the main casing.
FS-25 Rear Axle/Differential
A. A spool, limited slip or locker or welded spider gears are allowed.
B. Ring and pinion gear ratio is open.
C. Gusseting or strengthening of the rear end housing is allowed.
FS-26 Dip Sticks
A. All dipsticks must be secured in dipstick tube with a positive locking or secured method.
FS-27 Drive Shaft
A. Drive shaft loop must be utilized to retain drive shaft.
B. Drive shaft must be painted white and have vehicle number on it.
FS-28
Tires & Wheels
A. Tire must be D.O.T. and available to the general public through normal dealer distribution.
B. Maximum tire diameter is 33 inches.
C. Beadlock wheels are permitted.
D. No inner liners allowed.
E. Wheels must be in good repair and may be made of either steel or aluminum.
F. Wheel covers are not permitted.
FS-29 Transponders/Timing
A. All teams are required to purchase remote timing transponders. Transponder numbers must
be recorded with LORORS officials.
B. Drivers are responsible for the charging and installation of all transponders. Any entry
without a properly charged, properly installed, functioning transponder may not be scored.
C. Transponders must be placed from front face of the front bumper center line 10 inches back
on the driver’s side of the the truck.
LUCAS OIL REGIONAL OFF ROAD SERIES MINI OPEN TRUCK RULES
21