Turbonetics 350Z Turbo Kit Installation Manual 15134-t.pdf

You can purchase this part at: http://thmotorsports.com
FIGURE 61 FIGURE 62
NOTE: Now that all exhaust tubes are loosely installed, go thru and tighten all the hardware & clamps.
75. Install the bottom half of the 5/8” oil drain hose to the oil drain fitting in the block, and secure with the attached
hose clamp (pointed out in FIGURE 60). Cut the length of the hose to suit, so that no part of the hose is lower
than the fitting in the block. Route the hose (downward from the turbocharger) away from hot exhaust pipes,
and secure with zip ties. If any heat shield wrap is left over, use as needed.
76. Install the bottom half of the braided oil supply hose to the engine (pictures of bottom front of engine), per the
following steps: (Be sure to use NPT thread sealant on all NPT connections)
A. Remove the electrical connector and the oil pressure sensor from the engine block (circled in FIGURE 63)
B. Using the supplied 1/8” NPT tap (P/N 30808), carefully re-tap the vacated hole in the engine block
C. Install the 1/8” NPT “Tee” fitting (P/N 30562) into the re-tapped hole (pointed out in FIGURE 64)
D. Re-install the pressure sensor into the opposite end of the “Tee” fitting
E. Install the 1/8” NPT x –3 straight oil fitting (P/N 30544) into the third leg of the “Tee” fitting
F. Install the braided oil supply line into the oil fitting from the previous step (SEE FIGURE 64).
FIGURE 63 FIGURE 64
77. Install the mounting brackets (P/N 21203) to the intercooler end tanks, using (2) 1/4-20 x 1/2” hex bolts &
lockwashers. Install the intercooler (P/N 5-312) assembly to the car using the factory bolts, as shown in
FIGURE 65 & 66.
60130_revG_350Z_manual.doc Page 28 of 35
More installation manuals at: www.thmotorsports.net