maintenance - Polaris
maintenance - Polaris
maintenance - Polaris
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Reverse Operation<br />
Electronic Reverse (PERCt)<br />
OPERATION<br />
Electronic reverse will activate only if the engine is below 4000 RPM.<br />
If your machine is running at an altitude of over 6000 feet, adjust the<br />
ignition setting as described below. Always make sure the vehicle is<br />
stopped and the engine is running at idle before shifting to reverse.<br />
1. Make sure the area behind your vehicle is clear.<br />
2. Push the yellow reverse button on the left-hand control for one<br />
second, then release. The engine will automatically reduce RPM and<br />
start a reverse rotation. A flashing reverse light on the instrument<br />
panel will indicate that the machine is in reverse.<br />
3. Slowly apply the throttle until movement starts and you’re sure the<br />
machine is in reverse.<br />
NOTE: The maximum engine RPM will be 6000 when in reverse.<br />
NOTE: If the engine stops running, the snowmobile will be in forward<br />
gear when it’s restarted.<br />
CAUTION<br />
Operating the electric starter or the recoil while the engine is<br />
running can result in personal injury and/or engine damage. Do not<br />
operate the electric or pull-rope starter while the engine is running.<br />
Disengaging Reverse<br />
Push the yellow reverse button on the left-hand control for one second<br />
and release. The engine will slow and and begin to rotate forward.<br />
The light on the instrument panel will shut off. Make sure the area<br />
around your vehicle is clear and apply throttle slowly until you’re sure<br />
the machine is in forward gear.<br />
Altitude Setting<br />
At higher altitudes (above 6000 feet), the engine will require a different<br />
ignition setting to improve the success of the reverse system. To set<br />
for a higher altitude, start the engine and hold the button down until the<br />
light on the instrument panel flashes rapidly, then release the button.<br />
To set the reverse for lower elevations, continue holding the button<br />
down until the reverse indicator light blinks slowly. Once set, it’s<br />
stored in memory until changed, whether the machine is running or<br />
not.<br />
81