BUGGYPOD COMPATIBILITY Buggypod io Buggypod Smorph 2

compatibility Buggypod io & Smorph
Bolero p p
PLEASE NOTE: Adding the Buggypod to a twin pushchair may create a particularly wide and heavy load to push around
Revelo does not guarantee that the Buggypod will fit every make and model of pushchair. Customers should always follow our guidelines:
The Buggypod can be attached to most buggies and pushchairs including twin buggies and 3 wheelers.
The strap of the mounting brackets can be tightened around most buggy and pushchair frames.
The frames can be oval, square, round, thick or thin.
Size 51 brackets fit frames up to 4 cm diameter. Size 70 brackets fit frames more than 4 cm diameter
The Buggypod is supplied with a set of size 51 brackets included. Size 70 brackets are available to purchase separately.
To assess whether the Buggypod will fit your pushchair, you should check that there are exposed fixture points
on two major frame tubes on the right hand side of your pushchair.
On the Buggypod Smorph, the rear fixture point needs to be approximately 35-43 cm from the floor.
On the Buggypod iO, the rear fixture point needs to be approximately 29-41 cm from the floor.
The front fixture point can be level with the rear fixture point or up to approx. 8 cm higher.
27