Untitled - ESMA, Inc.
Untitled - ESMA, Inc.
Untitled - ESMA, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1. Heater – The tanks are supplied with 400 watts of heat controlled by an<br />
adjustable, internal thermo switch. The thermo switch has been adjusted to<br />
control the bath temperature at 160degrees F when tank covers are on. If<br />
temperature needs to be changed, there is a port at the rear of each tank<br />
module where a screwdriver can be used to adjust the control knob of<br />
thermostat. The thermostat is the same as used in the drying chamber<br />
mentioned below. Use the same procedure for adjusting the temperature but<br />
use caution that the bath temperature does not exceed 180 degrees F.<br />
CAUTION – Before adjusting thermostat turn power OFF.<br />
2. Timer – Digital solid state timers have been installed in the unit. (See<br />
separate instructions). Simply set the time with the ↑ or ↓ button.<br />
After time has been set, push START-STOP button and ultrasonic<br />
cleaning/rinsing or hot air drying will commence for the set time. The<br />
cycle can be stopped at any time by momentarily turning the main switch<br />
OFF. An alarm will sound when the time has expired and the timer will<br />
return to the set time setting. Press and hold the START-STOP button at any<br />
time for to return the timer to the set time.<br />
3. Drying Chamber – The drying chamber uses forced hot air thermostatically<br />
controlled at 160 degrees-180 degrees F. (set by the manufacturer) Drying time<br />
will vary depending on the number of parts to be dried, if hot or cold water was<br />
used to rinse parts before drying and if the cover is on oven. Generally parts<br />
should be dry in 10 minutes.<br />
CAUTION: Parts after drying will be hot (170 degrees F) and should be cooled<br />
before touching.<br />
The air temperature of the dryer has been set at the factory to reach 170degrees F with<br />
cover on the oven. If you want to change the temperature, there is a thermostat<br />
mounted above blower in closed chamber behind oven. The temperature can be<br />
changed as follows:<br />
1. Disconnect unit from 120V outlet.<br />
2. There is a port at rear of dryer module<br />
where a screw driver can be inserted to<br />
adjust the temperature.<br />
3. Move control knob of thermostat slightly<br />
in clockwise direction to increase<br />
temperature and counter-clockwise to decrease temperature. Make only<br />
slight changes because a 30 degree angle change corresponds to an<br />
approximate 20 degrees F temperature change. Replace top plate on<br />
chamber.<br />
5