HD3000 - Janome

More documents

Recommendations

Info

Threading the Bobbin Winder e r w t y u i er q Pull the clutch knob away from the machine to disengage the clutch. w Draw the thread from the spool. e r t Guide the thread around the thread guide. Guide the thread around the bobbin winder thread guide. Insert the thread through the hole the bobbin, threading from the inside to the outside. o q y u i o Put the bobbin on the bobbin winder spindle, and push it to the right. With the free end of the thread held in your hand, depress the foot control. Stop the machine when it has made a few turns, and cut the thread close to the hole in the bobbin. Depress the foot control again. When the bobbin is fully wound, it will sotp automatically. Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread as shown. Push in the clutch knob to engage clutch. * The machine will not sew untill the clutch knob is pushed in. 16
Inserting the Bobbin Place the bobbin in the bobbin holder with the thread running counter-clockwise. Guide the thread into the notch A on the front side of the bobbin holder. Draw the thread to the left sliding it between the tension spring blades. Continue to draw the thread lightly until the thread slips into notch B. Pull out about 15 cm (6˝) of thread and attach the hook cover plate. 17
Page 1: INSTRUCTION BOOK
Page 4 and 5: Do’s and Don’ts 1. Always be aw
Page 6 and 7: SECTION I ESSENTIAL PARTS Names of
Page 8 and 9: Foot Storage Compartment q w e r Ea
Page 10 and 11: SECTION II GETTING READY TO SEW Con
Page 12 and 13: Pressure Dial Dropping the Feed Dog
Page 14 and 15: To Detach and Attach the Foot Holde
Page 16 and 17: Thread and Needle Chart Fabrics Thr
Page 20 and 21: Threading the Machine e r t q w q w
Page 22 and 23: Drawing Up Bobbin Thread q Raise th
Page 24 and 25: Pattern Selector Dial Zigzag Width
Page 26 and 27: Changing the Sewing Directions Stra
Page 28 and 29: Overedge Stitch Tricot Stitch Machi
Page 30 and 31: Sewing Buttons Machine Setting Tape
Page 32 and 33: Touch Starting point r t Bottonhole
Page 34 and 35: Manual Buttonhole Machine Setting q
Page 36 and 37: Corded Buttonhole Machine Setting q
Page 38 and 39: To Sew: Fold back the left seam all
Page 40 and 41: Rolled Hem Machine Setting Make a d
Page 42 and 43: Blind Stitch Hemming Machine Settin
Page 44 and 45: Adjusting Stretch Stitch Balance Sm
Page 46 and 47: Pin Tucking Machine Setting Positio
Page 48 and 49: Applique Patch Work Machine Setting
Page 50 and 51: Cleaning the Hook Race Inserting th
Page 52: Condition Cause Reference Seam Puck

HD3000 - Janome

Create successful ePaper yourself

Delete template?

Save as template?