User Manual - Remington Sporting Dog
User Manual - Remington Sporting Dog
User Manual - Remington Sporting Dog
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
24<br />
• Place the magnet key ring end directly on<br />
the indented circle on the collar unit and<br />
hold in place until you hear the ascending<br />
melody, the collar unit will be in the<br />
ELEVATING PROGRAM MODE. (NOTE:<br />
You may have to cycle through the FIXED<br />
PROGRAM MODE levels first.)<br />
• Place the magnet key ring end directly on<br />
the indented circle to switch back to the<br />
FIXED PROGRAM MODE. The unit will begin beeping, indicating the<br />
impulse/stimulation level that can be chosen, from 1 to 8. Count the number<br />
of beeps that correspond to the levels below and on the next page.<br />
When you hear the desired number of beeps, simply remove the magnet<br />
key ring from the collar unit. The level will stay set until you change it using<br />
the same process. We recommend starting out at the lowest level and<br />
increasing the levels until the barking stops.<br />
• 1 beep tone indicates level 1 impulse/stimulation<br />
• 2 beep tones indicates level 2 impulse/stimulation<br />
• 3 beep tones indicates level 3 impulse/stimulation<br />
• 4 beep tones indicates level 4 impulse/stimulation<br />
• 5 beep tones indicates level 5 impulse/stimulation<br />
• 6 beep tones indicates level 6 impulse/stimulation<br />
• 7 beep tones indicates level 7 impulse/stimulation<br />
• 8 beep tones indicates level 8 impulse/stimulation<br />
• To revert back to the ELEVATING PROGRAM MODE, hold the key<br />
ring magnet end directly on the indented circle on the collar unit until<br />
you hear the ascending melody, indicating that the ELEVATING<br />
PROGRAM MODE is set, then move the magnet key ring away from<br />
the collar unit.<br />
• You may check at any time, the level that your collar unit is set to by<br />
briefly holding the magnet key ring to the indented circle on the collar<br />
unit until there is a tone. Quickly remove the magnet key ring. This<br />
tone will correspond to the level your collar unit is programmed to.<br />
IMPORTANT: the program chosen is retained even<br />
when the battery is removed and replaced.<br />
ADDITIONAL INFORMATION:<br />
• After inserting the battery or changing the program, the collar unit<br />
automatically enters a 1 minute standby period during which no impulse/<br />
stimulation is possible.<br />
• The minimum time between 2 impulse /stimulations is 5 seconds.<br />
• The maximum number of impulse /stimulations that can occur is 8.<br />
• The collar unit will enter a standby mode if the dog has been impulse/<br />
stimulated 8 times.<br />
• The unit will reactivate from the standby mode after 2 minutes.
Change language