In s ta lla tio n , O p e ra tio n a n d M a in te n a n c e In s tru ... - Ventia

More documents

Recommendations

Info

Assembling and operational instructions Design air curtain Arcus-E 2 3 4 STAVOKLIMA v.o.s. Basic information about the product, usage, application Air curtain is an equipment, which protects the heated area against entering the cold air inside (in the summer season also protects against the warm air entering into the areas which are air conditioned). These equipments are suitable to be used in standard areas that means without a humidity. They are also not suitable for the areas with elevated dustness, for excessive cool or hot operations - allowed temperature range in the area is 5-40°C ! As a separating medium it is possible to use either circulation air of room temperature or circulation air heated by an alectrical or hot water heater. In air conditioned areas you can save a big part of costs connected with cooling the area. Full power of the air curtain can be guaranteed only by regular servicing. Each of the operational component units is accessible and easy to maintain. Technical conditions for unit operation: max. working medium temperature 90°C / pressure 1,6 Mpa max. surrounding temperature 40°C / degree of protection IP 44 operating voltage 230V-50Hz (if it is not ordered in different voltage) The unit is intended for basic and nonagressive environment. Filtration quality of inbuilt filter (only at water heated a.c.) is G2. Possibilities of unit installation Installation on left side of the door Unit mounting - anchorage into the floor Installation right from the door The air curtain Arcus (Arcus-x) is designed as a vertical air curtain with the medium connection (electro cables) from bottom part of the unit (in case the customer doesn´t want it in a different way). The bottom part of the unit is composed of basic anchorage plate, residual stud and bottom side plate of the air curtain, which is a part of the air curtain. On delivery you will receive from the producer these parts put together through the plastic stripes (only because of the transport reasons). Before the mountaing it is necessary to take away the anchorage plate so you cut the stripes. The access to the basic plate is possible after opening the suction grill, which is also an inspection cover at the same time. The grill is openable after removing the plastic end caps and demounting the Alien screws. Be careful when demounting the basic plate to avoid while dropping any injury or damage of the part. The producer reserves the right to make changes due to marketing or production rules, without prior notice ! -- 4 -- MPN-ARCUS-E-A-DITRONIC
Assembling and operational instructions Design air curtain Arcus-E STAVOKLIMA v.o.s. placing the plastic cover of the screws on the suction grill repeated closing of the suction grill According to the picture hereunder do the preparation for anchorage (inner) plate of the side plate on the building floor. The building floor has to be in final stage of the construction work that means after coating, concrete, pavement or with final surface! Mark the anchorage places and drill out the holes for the connectors and anchors. Check the absolute horizonatl level of the basic plate! Pass through the hole for electro all the connection cabels and fix the plate on the prepared medium pipes. !!Placement of the mediums and the ending length make accurate according to the wiring diagram!! The cables for connection leave free min. as the unit height (some of the cables go up to the top part of the unit). The producer reserves the right to make changes due to marketing or production rules, without prior notice ! -- 5 -- MPN-ARCUS-E-A-DITRONIC
Page 1 and 2: Installation, Operation and Mainten
Page 3: Assembling and operational instruct
Page 7 and 8: Assembling and operational instruct

In s ta lla tio n , O p e ra tio n a n d M a in te n a n c e In s tru ... - Ventia

Create successful ePaper yourself

Delete template?

Save as template?