In s ta lla tio n , O p e ra tio n a n d M a in te n a n c e In s tru ... - Ventia

Assembling and operational instructions Design air curtain Arcus-E
6
STAVOKLIMA v.o.s.
5-1-4
Preparing for electro connection, fuse and setting
Electro investigations must be performed by a qualified person according to ČSN 34 3205 and notice No. 50-
51/1979 law. Electro connections make exactly according to the delivered wiring diagrams. Don´t forget to do the
corresponding protective earthing. Always think over the suitability of recommended cable connections with regard
to fire section of the building, protective distance, fuse and stage of the building electro installation.
After the mounting check carefully everything and do the initial unit revision. Don´t forget also to fill in
the data about mounting into the warranty card. Check the fuse function for the internal circuits
(exchanging of the fuse is described hereunder) and setting of the unit time item (setting of the time item
described hereunder). Do also all prescribed bridges - from preventing of complicated searching fault
source. Also assure yourself about the function of external elements (accessories), which can have
substantial influence on the right unit function.
Electrical connection
Do all connections of prepared cables to the grips according to the applied electro documentation, afterwards
check the connections, earthing and finally switching on the power supply.
The electro-holes for cables are always placed by default in the lower part of the unit - anchorage and sliding
plate (pic.). When doing electrical services it is necessary to open - tip the exchanger and pass through the
cabels into the heat exchanger bushings. When doing the connections mind the cables can´t be too short and
also too long, as this would stand in the way to close the exchanger. So see to it that you won´t squeeze the
cable into the exchanger. Electric terminal box is accesible after opening the suction grill and unscrewing the
cover of the electric box (pic.)
passage for all electrical cables
removing the cover of lower connection
lid removing of
the lower
electricl box
and main
connection
grips
position of connecting terminal box
See to it, that the cable won´t be distortioned or however deformed. The free endings of separate cable wires
leave long enough because of easy manipulation, not before you will be sure the wire is long enough make
the shortening. The hole for the electro-cable is intended as for the power suplly cable entry, but also for all
others controlling cables.
All electrical work should be carried out in accordance with current regulations in given country and according
to ČSN 12 2002 and other linked rules. At any service intervention the unit must be disconnect. Connection
and earthing of electric unit or its parts has to correspond especially with ČSN 332190, 332000-5-51, 33 2000-
5-54. All electrical investigations must be performed by a qualified electrician according to the notice §6 ČBU
No.50/78 law.
The producer reserves the right to make changes due
to marketing or production rules, without prior notice !
-- 7 -- MPN-ARCUS-E-A-DITRONIC