Conforms To ANSI STD Z21.58a - Smoke Hollow Smokers by ...
Conforms To ANSI STD Z21.58a - Smoke Hollow Smokers by ...
Conforms To ANSI STD Z21.58a - Smoke Hollow Smokers by ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Assembly<br />
Step 20<br />
Step 21<br />
Fig. 21B<br />
Fig. 21A<br />
Fig. 21C<br />
18<br />
Step 20: Attach Charcoal Damper Handle<br />
Locate: Charcoal Damper Handle<br />
Procedure:<br />
Screw the handle into the hole located above<br />
the vertical slots on the charcoal side of the<br />
grill. The handle should slide back and forth<br />
to open and close the damper.<br />
Step 21: Install Warming Rack<br />
Locate: Warming Rack and (2) M6x25 bolts<br />
Procedure: The warming rack can be<br />
attached to either side of the grill. <strong>To</strong> attach<br />
the warming rack, insert (1) of the M6x25 bolts<br />
through the lid from the outside as shown in<br />
Figure 21A and position the warming rack so<br />
that the bolt is going through the wire loop as<br />
shown in Figure 21B. Then align the wire loop<br />
on the opposite end of the warming rack with<br />
the opposite lid hole and insert the other<br />
M6x25 bolt.<br />
Insert the wire legs into the holes on the sides<br />
of the cabinet as shown in Figure 21C.
Change language