ELECTRONICS

CONTA-ELECTRONICS
Potentiometric converter units CML
CML-POT-UI
· Mount on TS 35
· Compact design, width: 6.2mm
· Screw-clamp connection
· Conversion of potentiometer signals into standard
analog signals
· Suitable for 1 k to 20 k Ω potentiometer
· Output: 0 to 10 V, 0 to 20 mA, or 4 to 20 mA
· Output signal is adjustable via DIP switch
· OFFSET and SPAN setting is always accessible
Circuit diagram
Type
Cat. no./Qty. p.pck.
Size (L x W x H) with TS 35 x 7.5
Weight
General information
DIN-VDE specifications
Electro-magnetic compatibility
Protection class
Operating temperature
Connection type
Insulation stripping length
Conductor cross-section
Screw-clamp / tension-spring connection
Conversion error
Temperature coefficient
Frequency limit (- 3dB)
Power supply
Input data
Potentiometer
Minimal use of potentiometer
for OFFSET/SPAN adjustment
Remarks:
Output data
Voltage of output signal
Max. voltage of output signal
Load resistance
Current of outputs (adjustable via DIP switch)
Max. output current
Load resistance
Offset
Remarks:
CML-POT-UI
15641.2/1
93.1 x 6.2 x 102.5 mm
66 g
DIN EN 50178:1987; DIN VDE 0110 pollution degree 2, overvoltage category III
CE compliant
IP 20
-20 to +55°C
Screw-clamp/tension-spring connection
12mm/8mm
0.2-2.5mm 2
AWG 22-14
< 0.2% of end value
< 0.02%/K
10 Hz
24 V DC -15% +10%/40 mA
0 to 1 kΩ to 0 to 20 kΩ
60%
first adjust offset, then span
0 to 10 V (default)
approx. 11 V
> 1 kΩ
0 to 20 or 4 to 20 mA (default is 4 to 20 mA)
approx. 22 mA
< 500 Ω
< 10 mV/20 mA
when the current and voltage outputs are used simultaneously, the load resistance must be
> 10 kΩ on the voltage output.
138