ELECTRONICS

Analog signal converter modules without galvanic isolation CAE
CAE / I-U / 0-10 mA CAE / I-U / 0-20 mA CAE / I-U / 4-20 mA
· Mount on TS 32/TS 35
· Screw-clamp connection
· Conversion of a standard analog signals without
galvanic isolation
Circuit diagram
Type
Cat. no./Qty. p.pck.
Size (L x W x H) with TS 35 x 7.5
Weight
General information
DIN-VDE specifications
Operating temperature
Insulation stripping length
Connection cross-section
Screw-clamp connection
Conversion error
Temperature coefficient
Input data
Input signal
Max. input signal
Input resistance
Output data
Output signal
Max. output signal
Load resistance
Power supply
Max. transmission frequency
CAE / I-U / 0-10 mA
6754.2 /1
87 x 25 x 73 mm
50 g
DIN EN 50178; DIN VDE 0110,
pollution degree 2,
overvoltage category III
0 to +50°C
7mm
0.2-2.5mm 2
AWG 22-14
< 0.4% of end value
< 0.02%/K
0 to 10 mA
15 mA
50 Ω
0 to 10 V
12 V
> 1 kΩ
24 V DC ± 10%/25 mA
100 Hz
CAE / I-U / 0-20 mA
6755.2 /1
87 x 25 x 73 mm
50 g
DIN EN 50178; DIN VDE 0110,
pollution degree 2,
overvoltage category III
0 to +50°C
7mm
0.2-2.5mm 2
AWG 22-14
< 0.4% of end value
< 0.02%/K
0 to 20 mA
25 mA
50 Ω
0 to 10 V
12 V
> 1 kΩ
24 V DC ± 10%/25 mA
100 Hz
CAE / I-U / 4-20 mA
6756.2 /1
87 x 25 x 73 mm
50 g
DIN EN 50178; DIN VDE 0110,
pollution degree 2,
overvoltage category III
0 to +50°C
7mm
0.2-2.5mm 2
AWG 22-14
< 0.4% of end value
< 0.02%/K
4 to 20 mA
25 mA
50 Ω
0 to 10 V
12 V
> 1 kΩ
24 V DC ± 10%/25 mA
100 Hz
Converter Units
145