Lamp and Ballast Catalog - The Lighting Company
Lamp and Ballast Catalog - The Lighting Company
Lamp and Ballast Catalog - The Lighting Company
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>The</strong><strong>Lighting</strong><strong>Company</strong>.com<br />
F<br />
L<br />
U<br />
O<br />
R<br />
ESCE<br />
N<br />
T<br />
SYMBOLS & FOOTNOTES FOR FLUORESCENT LAMPS<br />
Footnote Description<br />
96 SAFELINE lamps satisfy the criteria of having a non-shattering covering for prevention of glass <strong>and</strong> other lamp components in your product<br />
by containment within the safety coating material. <strong>The</strong> covering must be intact or the lamp must be replaced to be in compliance. An onsite<br />
inspector will require correction if the lamps are installed improperly or not maintained properly.<br />
97 Average life rating at 12 hours operation per start is 18,000 hours.<br />
98 SAFELINE lamps are intended for indoor use only. <strong>Lamp</strong>s must be used in ambient temperatures below 135 degreed F. <strong>The</strong> coating is<br />
designed to withst<strong>and</strong> constant operating temperatures up to 239 degrees F <strong>and</strong> has a melting point in excess of 500 degrees F. <strong>Lamp</strong>s must<br />
be used with sockets that provide adequate lamp pin to socket contact. <strong>Lamp</strong>s must not be used with defective ballasts sockets, or fixtures<br />
with improper wiring.<br />
99 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 1 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.25 meters (10 inches) should be limited; for example exposure at 0.14m (6 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
100 WARNING: ICETRON® Inductively Coupled Electrodeless Fluorescent lamp. Read these warnings <strong>and</strong> instructions before installing <strong>and</strong> using<br />
this lamp. 1. This lamp operates at a higher temperature (130 C) than st<strong>and</strong>ard fluorescent lamps. To avoid the possibility of minor skin<br />
burns, do not touch lamp or metal mounting brackets during operation <strong>and</strong> allow sufficient cooling time prior to servicing, h<strong>and</strong>ling, or<br />
replacing lamp. 2. This lamp generates electric <strong>and</strong> magnetic fields during operation. <strong>The</strong> electric <strong>and</strong> magnetic fields generated by this lamp<br />
during operation in typical lighting applicatons do not pose exposure risks relative to the limits documented in ANSI C95.1. 3. To prevent<br />
electric shock, shut off the main power to the fixture <strong>and</strong> allow at least two minutes for ballast voltage to discharge before attempting to service<br />
or replace lamp. 4. To obtain optimum safety <strong>and</strong> system performance, use only with OSRAM SYLVANIA ballast. 5. To avoid potential<br />
electric shock hazard, do not use lamp if wires or insulation are cut or pulled out of connector.<br />
101 WARNING: ICETRON® Inductively Coupled Electrodeless Fluorescent lamp. Read these warnings <strong>and</strong> instructions before installing <strong>and</strong> using<br />
this lamp. Instructions for Installation <strong>and</strong> Use. 1) To avoid premature lamp or ballast failure <strong>and</strong> ensure proper lamp, ballast, <strong>and</strong> system<br />
performance, make sure lamp, ballast, <strong>and</strong> fixture are properly installed. Electrical interconnects, electrical grounds, thermal management,<br />
<strong>and</strong> heatsinking specifications <strong>and</strong> requirements must be fully adhered to in all applications. (See OSRAM SYLVANIA ICETRON DESIGN<br />
GUIDE.) 2. Do not alter the electrical connector on lamp <strong>and</strong>/or ballast. To do so may adversely affect lamp operation, ballast life, <strong>and</strong>/or<br />
emission of EMI (electromagnetic interference). 3. This product may cause interference with radios, cordless telephones, <strong>and</strong> remote control<br />
devices. If interference occurs, relocate the radios, cordless telephones, <strong>and</strong>/or remote control devices away from this product.<br />
102 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 1 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.3 meters (12 inches) should be limited; for example exposure at 0.14m (6 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
103 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 1 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.35 meters (14 inches) should be limited; for example exposure at 0.25m (10 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
104 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 2 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.45 meters (18 inches) should be limited; for example exposure at 0.3m (12 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
105 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 2 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.55 meters (22 inches) should be limited; for example exposure at 0.4m (16 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
106 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 2 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.65 meters (26 inches) should be limited; for example exposure at 0.45m (18 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
107 CAUTION: This lamp emits ultraviolet (UV) power during operation <strong>and</strong> is in Risk Group 2 per ANSI/IESNA RP-27.3-96. Exposure at less than<br />
0.7 meters (28 inches) should be limited; for example exposure at 0.54m (20 inches) should not exceed 4 hours in an 8 hour interval (see<br />
ANSI/IESNA RP-27.1-96). Certain medications <strong>and</strong> chemicals can increase an individual's sensitivity. Consult your physician for specific<br />
information. Protective eyewear should be worn in occupational situations involving long term exposure in close proximity to the lamp. This<br />
lamp is not intended <strong>and</strong> should not be used for diagnostic, therapeutic or cosmetic purposes.<br />
For more complete product information visit www.sylvania.com<br />
164<br />
<strong>The</strong><strong>Lighting</strong><strong>Company</strong>.com