Manual 1 - Tower Hobbies
Manual 1 - Tower Hobbies
Manual 1 - Tower Hobbies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MAIN ASSEMBLY ––––––––––––––––––––––<br />
NOTE: If you haven’t yet figured it out yet, the canopy hatch<br />
is held to the fuselage with magnets at the rear and a tab at the<br />
front. To remove the hatch, simply lift up on the aft end of the<br />
hatch to disengage the magnets.<br />
❏ 3. Connect the pushrods to the horns as shown.<br />
❏ 4. Insert one, then the other main landing gear wires into<br />
the wing – the wire struts are positioned inboard of the wheels.<br />
❏ 1. Fit the horizontal and vertical stabilizer (stab and fin)<br />
together, then fit them to the fuselage while keying the tail gear<br />
into the rudder.<br />
4<br />
❏ 2. Fasten the stab and fin assembly to the fuselage with the<br />
M3 x 40 screw.<br />
❏ 5. Guide the aileron servo wire through the hole in the bottom<br />
of the wing.