ASX-500/ASX-500 Model 510 Auto Sampler Software Developer's ...

ASX-500/ASX-500 Model 510
Auto Sampler Software Developer’s Manual
__________________________________________________________________
(24) WAIT-p
Waits for an input from AUX port n. (Relay, TTL, or transistor low
from pin 4 (+) to pin 23 (-) on AUXILIARY). WAIT can be terminated
by ESC from COM1.
Example WAIT-2 (Waits for input from AUX-2.)
Errors 007
__________________________________________________________________
(25) \
A backslash before a command connects com1 to com2. The command
is sent through to the next device and the Auto Sampler waits for a
from the accessed device to close the port. If a is not
returned in 60 seconds, the port is closed and an error message results.
The port can also be closed by sending a pipe (|) from the host
computer. Two backslashes will access the next device connected etc.
The from the last device in the chain will then close all ports and
return to the host.
Example
Errors
\(COMMAND) (Returns OK: from next device in
the chain.)
NONE
__________________________________________________________________
15