Electrospinning a Thermoelectric Polymer - Materials Science and ...

More documents

Recommendations

Info

Electrospin Modeling: Dimensional Analysis Helgeson 2008 Plot 24
Effect of viscosity: Too low viscosity à jet breaks up to polymer droplets à electrospraying Low viscosity causes formation of beaded fiber Very high viscosity à unable to pump the solution There is a viscosity range which electrospining is effective As viscosity increases so does the average fiber diameter 25
Page 1 and 2: ENMA490 Spring 2012 By: Natan Aronh
Page 3 and 4: 3 Thermoelectrics Bismuth Tellurid
Page 5 and 6: 5 Intellectual Merit Extend dimens
Page 7 and 8: 7 Basic Design High V Power Source
Page 9 and 10: 9 Material Selection Electrospin P
Page 11 and 12: 11 Technical Approach: VRH We will
Page 13 and 14: 13 Technical Approach: VRH Using im
Page 15 and 16: 15 Background: Electrospinning Und
Page 17 and 18: Electrospin Modeling: Dimensional A
Page 19 and 20: Electrospin Modeling: Experimental
Page 21 and 22: Electrospin Modeling: Determination
Page 23: Electrospin Modeling: Dimensional A
Page 27 and 28: Viscosity Tests on Clevios Solution
Page 29 and 30: 29 TE Modeling Results: σ ll (S/ c
Page 31 and 32: 31 Conclusions: Thermoelectric Goal
Page 34 and 35: Facilities Dr. Hu - electrospinnin
Page 36 and 37: References [1] Nidhi Dubey and Mar

Electrospinning a Thermoelectric Polymer - Materials Science and ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?