Electrospinning a Thermoelectric Polymer - Materials Science and ...

More documents

Recommendations

Info

TE Measurements on Prototype Seebeck Coefficient: S=−∆V/∆T Measure using voltmeter and thermocouple while heating Measured a value of 6.36 μV/K Attempted to measure electrical conductivity using four point probe: R= l/σA Unable to obtain measurements using 4 pt. probe
31 Conclusions: Thermoelectric Goals and Insight from Results Goal: to fabricate nanofiber TE device that rivaled that of PEDOT:PSS thin films in terms of Power Factor and efficiency Insight from Results: If percolation is reached, can obtain similar efficiency to a doped PEDOT:PSS thin film (Less conductive polymer required)
Page 1 and 2: ENMA490 Spring 2012 By: Natan Aronh
Page 3 and 4: 3 Thermoelectrics Bismuth Tellurid
Page 5 and 6: 5 Intellectual Merit Extend dimens
Page 7 and 8: 7 Basic Design High V Power Source
Page 9 and 10: 9 Material Selection Electrospin P
Page 11 and 12: 11 Technical Approach: VRH We will
Page 13 and 14: 13 Technical Approach: VRH Using im
Page 15 and 16: 15 Background: Electrospinning Und
Page 17 and 18: Electrospin Modeling: Dimensional A
Page 19 and 20: Electrospin Modeling: Experimental
Page 21 and 22: Electrospin Modeling: Determination
Page 23 and 24: Electrospin Modeling: Dimensional A
Page 25 and 26: Effect of viscosity: Too low visco
Page 27 and 28: Viscosity Tests on Clevios Solution
Page 29: 29 TE Modeling Results: σ ll (S/ c
Page 34 and 35: Facilities Dr. Hu - electrospinnin
Page 36 and 37: References [1] Nidhi Dubey and Mar

Electrospinning a Thermoelectric Polymer - Materials Science and ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?