You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SW2Pi Connection Method #3<br />
Connect the SA-2 at speaker level from the receiver’s speaker outputs,<br />
with fixed high-pass filter<br />
Use if:<br />
You wish to send your L & R speakers a high-pass filtered signal<br />
Your receiver has no “Pre-Out”, “Line Out” or “Subwoofer Out” jacks<br />
This method of connection is recommended if you have a receiver with no line level preamplifier output of any<br />
sort and you want your L & R speakers to receive a high-pass filtered signal. The SA-2 may be connected to<br />
the system at speaker level between the receiver and the speakers. The SA-2’s speaker-level output has a<br />
fixed 100Hz high-pass filter that removes frequencies below 100Hz before sending the signal on to the speakers.<br />
The speaker-level high-pass filter is not adjustable. This method is not recommended if the L & R speakers<br />
are large, full range models.<br />
1) Connect a pair of speaker cables from your receiver’s front L & R speaker output terminals to the SA-2’s<br />
INPUT FROM AMPLIFIER barrier strip.<br />
2) Connect a second pair of speaker cables from the SA-2’s OUTPUT TO SATELLITES barrier strip to the front<br />
L & R speakers.<br />
3) Connect the SA-2’s SUBWOOFER OUTPUT to the SW2Si input terminals with speaker cable.<br />
SW2Pi Connection Method #3<br />
8