Robert Adams Thermal Magnetic Motor - The Hydrogen Shop

More documents

Recommendations

Info

Recap on Motor Housing & Rotor Use only nonconductive material for housing and/or rotor. Remember the water proof aspect!! Drive shaft and hub need to be either brass or non magnetic stainless. Don't use any aluminum either on the rotor or in the motor housing!! Someone needed clarification. Magnets Remember we are using both sides of the magnets with this motor. This particular aspect is what allows this motor to be extraordinary. The water conduit between the north and south poles of the magnets is also of great importance. Remember that the stators have to be separated from one another by 180 degrees and also that they are on opposite sides of the rotor!! Also, you only have (2) stators with this machine and those (2) stators also act as the generator coils too.
Coil Winding Direction This is also very important!! One of the coils is left wound while the other is right wound. I was told which goes with north and which goes with south pole magnets, but I am unable to find those particular notes. Anyway, it is thought that Adams used repulsion in these particular motors, so we want to repel the magnets with our stators and not attract them. Anyway, I'll continue to look for those notes because it is paramount that we wind the coils the proper direction or the exercise is futile. The north pole magnet side coil is wound one direction while the south pole magnet side coil is wound the opposite direction. I'll try to find the proper particulars and get back to you. Coil Winding Direction (Clockwise & Counterclockwise) Quote: Originally Posted by Slovenia This is also very important!! One of the coils is left wound while the other is right wound. I was told which goes with north and which goes with south pole magnets, but I am unable to find those particular notes. Anyway, it is thought that Adams used repulsion in these particular motors, so we want to repel the magnets with our stators and not attract them. Anyway, I'll continue to look for those notes because it is paramount that we wind the coils the proper direction or the exercise is futile.
Page 1 and 2: Robert Adams Thermal Magnetic Motor
Page 3 and 4: Rotor Specs: Rotor should be made f
Page 5 and 6: Quote: Originally Posted by sucahyo
Page 7 and 8: Tuning Fun This motor is going to b
Page 9 and 10: 3) Have one stator on North pole si
Page 11 and 12: pm, so the housing must be very fir
Page 13 and 14: Anyway I forgot to mention that the
Page 15 and 16: Originally Posted by Slovenia Very
Page 17 and 18: I'll share more when I have it. Sec
Page 19 and 20: system and that is very likely inde
Page 21: electromagnet assemblies are separa
Page 25: the stator core a long as you need.

Robert Adams Thermal Magnetic Motor - The Hydrogen Shop

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?