laboratory certification procedure - International Safe Transit ...

You may use the following Check List to be sure that all pertinent information is included on your
videotape. This form is for your use and need not be returned with the forms and video.
CATEGORY FUNCTION TO TAPE DONE
A1/A2: Vibration
Overall View
Frequency run-through
Levelness of table
Phase Relationship (circles - Rotary Motion only)
Sample Testing: Use of Test Box and metal shim
B1/B2:
Incline/Horizontal
Impact
Overall view
Verification test (fill out back side of equipment form): impacts, free running
and loaded
Controls view
C1/C2: Drop/Shock
Overall view
Release mechanism shown
Sample Testing: drops on end, side, corner, edge
D: Compression Overall view
Sample Testing: Consistent compression rate
Sample Testing: Platen deflection
Controls view
E: Environmental
Chamber
Overall view
Controls view
F: Additional views Optional Show outside of lab, any non-lab office space, etc.
G. Additional
Equipment (submit
photos or drawings)
3B fork handling course (drawing or photo)
3A Top load apparatus (photo)
3A Hazard blocks (photo)
3A Small dunnage/bags (photo)
Submission Materials
(as applicable)
Equipment Verification Forms
Video(s)
Vibration Control Plots
Atmospheric Chamber graphs
Vibration Circles
Calibration Documentation
ISTA Laboratory Certification Procedures
Updated: September 2013
©2013 International Safe Transit Association. All rights Reserved.