Dell iDRAC Card Profile - Dell Community

1304
1305
1306
1307
1308
1309
8.5 DCIM_iDRACCardService.ApplyAttributes()
The ApplyAttributes() method is used to set or change the value of a iDRAC Card attribute.
NOTE: If setting numerous attributes at the same time, please make sure that WSMAN client has a timeout of at
least 120 seconds.
Table 105 – ApplyAttributes() Method: Return Code Values
Value
Description
2 Error
4096 Job Created
1310
Table 106 – ApplyAttributes() Method: Parameters
Qualifiers Name Type Description/Values
IN, REQ Target String FQDD of the iDRAC Card
IN, REQ AttributeName[] String
IN, REQ AttributeValue[] String
OUT Job CIM_ConcreteJob
REF
An array of values, where each value shall be
formatted in the following way:
#.
Example: “MyGroup#MyAttribute”
Shall contain the desired attribute values.
If the value is valid, the CurrentValue or
PendingValue property of the specified attribute
will be modified.
Returned to keep track of concrete job status
OUT MessageID[] String Error message IDs may be used to look-up in the
Dell Message registry files. For more information,
see Error Message Registry.
OUT Message[] String Error messages in English corresponding to
MessageID is returned if an attribute set fails
1311
Table 107 – ApplyAttributes( ) Method: Standard Messages
MessageID (OUT parameter) Message MessageArguments[]
RAC001
RAC002
RAC003
RAC004
RAC005
RAC006
RAC007
RAC008
RAC009
The command was succesful
General failure
Missing required
Invalid parameter value for
Mismatch in AttributeName and
AttributeValue count
AttributeValue cannot be changed for
ReadOnly Attrinbute Name
Input out of range
Invalid boolean Value
String Exceeds max length
AttributeName, AttributeValue,
Target
AttributeName, AttributeValue,
Target
68 Version 1.3.0