General Catalogue RITMO - KIV Marketing Corporation

POLYWELD 2230 & POLYWELD 2048
POLYWELD
Welding cable + optical pen
These universal-kind of electrofusion machines are suitable for welding
low voltage Polyethylene (PE) couplers (from 8 to 48 Volts) for high pressure
conduits.
The POLYWELD machines are made in compliance with the current
European standards and directives, and distinguish themselves only by the
input: 230 V for the POLYWELD 2230, and 48 V for the POLYWELD 2048.
Both of them have a computer control of the welding cycle, and feature an
optical pen for reading the couplers bar codes. It is possible to set
voltage/time parameters manually, to store up to 150 welding cycles and to
transfer them directly to a PC or printer. Any kind of information (even
regarding malfunctions that could occur before or during welding) can be
viewed on the display, thanks to the machines’ software.
The machines are supplied with a cable with Ø 4 mm connectors, a set of
Ø 4,7 mm adapters and a manual scraper, most useful to remove the layer
of oxidation from the pipe (which could undermine the good result of the
welding).
SUPPLIED WITH
- Welding machine complete with optical pen, cable with Ø 4 mm
connectors and Ø 4,7 mm adapters;
- Manual scraper;
- Transport wooden case.
Manual scraper
ON REQUEST (ACCESSORIES)
ELECTROFUSION MACHINES
- HIGH PRESSURE FITTINGS -
Transport wooden case
Ø 4 / 4,7 mm adapters
Special adapters for
GF Elgef 24V coupler
- 230 V / 48 V voltage transformer (for POLYWELD 2048);
- Special adapters for electrical couplers type GF Elgef 24 V;
- Special adapters for electrical couplers type FRIALEN double-wire;
- Parallel printer data transfer kit, in order to transfer the welding data
from the machine directly to a parallel printer (includes a Serial/Parallel
converter and a Parallel/Centronics cable);
- Serial printer data transfer kit, in order to transfer the welding data
from the machine directly to a yard serial printer (includes a printer and
a DIN/DB9 cable);
- Parallel printer MEMO device with data transfer kit, in order to store
the welding data and then transfer them into a parallel printer (includes
a “MEMO” device with power supply and a Parallel/Centronics cable);
- PC MEMO device with data transfer kit, in order to store the welding
data and then transfer them into a PC (includes a “MEMO” device with
power supply, a PC data transfer/management software and a
DIN/DB25 cable);
- PC data transfer kit, in order to transfer the welding data from the
machine directly into a PC (includes a PC data transfer/management
software, a DIN/DB25 M cable, a DB25 F/F adapter and a DB25 M/DB9
F adapter).
Special adapters for FRIALEN
double-wire coupler
80