Conveyor-belt scale program by PFREUNDT Save ... - Pfreundt GmbH

NEW
In the new BW-2 S for static
applications, you have a low-priced
weighing system that you can
assemble yourself.
For static conveyor belts with a standard
frame width of up to 1150 mm (45 in.) or
1600 mm (63 in.).
Easy self-assembly
You can easily assemble the BW-2 S yourself.
In this way you save on additional service personnel,
doubling the value of your weighing system.
Mechanic pre-assembled
You can easily install the pre-assembled components by
following the clearly laid out instructions.
Electronics pre-installed
A prefabricated cable with plugs permits the straightforward
connection of the sensor to the WK 50-S BW evaluation unit –
the electronics need not even be opened.
System pre-calibrated
The weighing electronics are pre-set in our factory.
All you need to do is set a few belt parameters and the scale
is independently precise and ready to be employed.
When needed, you can further optimize the measured values
in the installed scales by running comparative weighings and
by fine-tuning the electronics.
Clear instructions are included in
the scope of supply.
You can however – as is the case for all PFREUNDT weighing
systems – prefer to have one of our service technicians install
and adjust the BW-2 S. The extensive service network of our
own employees means that we are always within easy reach.
• You will find options and accessories listed on page 5
Standard scope of supply BW-2 S
(Weighing frame 1150 or 1600 mm –
depending on the conveyor belt)