Above NEMA Motor Application Manual

Application Manual for Above NEMA Motors
Type CGII — Horizontal Custom — Weather Protected Type II
Anti-Friction Bearing
Frames 588-5810
Section
Part
Page
Date
1
1.2
3
9/96
Supersedes Page 8 Date 5/96
C
N-W
N
ES
P
U
52.5
14.50
2F
B
10.5 TYP
10.0 = BA
E
29.00
E
5.50 TYP
Standard Dimensions in Inches
Shaft Frame RPM B C E 2F N N-W P R(2) S(3) U V(1) ES
Approx.
Ship Wt. (Lbs.)
Short 588S 3600 43 55.1 11.5 28 7.0 6.75 53.5 2.45 .875 2.85 6.5 5.0 5300
Short 588S 1800 & Slower 43 56.4 11.5 28 8.25 8.0 53.5 3.436 1.0 4.0 7.75 6.0 5600
Short 5810S 3600 51 63.1 11.5 36 7.0 6.75 53.5 2.45 .875 2.85 6.5 5.0 6500
Short 5810S 1800 & Slower 51 64.4 11.5 36 8.25 8.0 53.5 3.436 1.0 4.0 7.75 6.0 6800
Long 588 1800 & Slower 43 63.0 11.5 28 14.9 14.62 53.5 4.169 1.25 4.875 14.38 13.0 5600
Long 5810 1800 & Slower 51 71.0 11.5 36 14.9 14.62 53.5 4.169 1.25 4.875 14.38 13.0 6800
Notes
See Section 6 for selection of main terminal box.
R(2)=Bottom of key to opposite side of shaft
S(3)=Width of keyset
V(1)=Length of shaft available for coupling or pully.
Jack screw holes and dowel holes are provided at each foot.
Shims may be necessary under motor feet for direct connection.
3600 RPM machines rotate in one direction only.
1800 RPM and slower machines may rotate in either direction.
Short shaft is for direct connection only.
Long shaft may be either belt drive or direct connect depending on bearing
installed in motor.
Certification
Customer P.O. S.O. Item
HP RPM FR. PH/HZ/Volts
Rotating Facing Shaft Extension CW CCW Either
By
Not for construction, installation or application purposes unless certified.
Date