FEATURED PRODUCTS - ATEC Trans-Tool

AUTOMATIC TRANSMISSION TOOLS
GENERAL MOTORS
125, 125C (3T40) (3T40E)
T-0154- HD
SLIDE HAMMER SET
HEAVY DUTY
* With 3/8” threaded
shaft tip
T-0154- E
1/2” SLIDE HAMMER
ADAPTERS
[Use with T-0154-HD]
T-1200
HOLDING FIXTURE
WITH BASE
(Also 440-T4, 4T60-E)
T-1200- F
HOLDING FIXTURE
WITHOUT BASE
T-1201
OUTPUT SHAFT
C-RING REMOVER &
INSTALLER
GM TRANSMISSION
TOOLS-EQUIP
T-0
T-1264
CONVERTER END
PLAY CHECKER
Also use as a side gear
checking tool
(Also 200-4R, 4T60E,
4L60E, 3L80)
T-1059- B
METAL LO-REVERSE
CLUTCH CENTER SUP-
PORT UNIT REMOVER-
INSTALLER
(Also 200, 200C,325, 325-4L)
T-1059-HD
METAL LO-REVERSE
CLUTCH CENTER SUP-
PORT UNIT REMOVER-
INSTALLER
* Positive locking action.
Works with or without
bushing intact
* Built-in slide hammer - to
remove “bound” housings.
(Also 200, 200C,325, 325-4L)
(Also 440-T4, 4T60-E)
T-1202- A
CLUTCH ASSEMBLY
AND FINAL DRIVE
REMOVER-INSTALLER
(Also 440-T4, 4T60-E)
T-1203
OUTPUT SHAFT LOAD-
ING AND
ALIGNING TOOL
(Also 325, 325-4L, 440-T4,
4T60-E)
T-1205
SEAL BEARING RACE
INSTALLER
[ Use with T-1093]
(Also 440-T4, 4T60-E)
T-1112
CUP PLUG INSTALLER
(Also 325, 325-4L)
Reproduction of this material in whole or in part is strictly prohibited without prior
written consent by ATEC Trans-Tool, LP, including all part numbers, drawings, pictures,
logos, or descriptions.Reproduction of any or any part of these items is civilly and/or
criminally punishable by law.
Contact Your Local Distributor PH: 1-800-531-5978 24 Hr. FAX 210-225-2114
or Tool Truck Dealer
www.atec-trans-tool.com
40