skybar ONE Wine System Manual - BeverageFactory.com

SETUP
Setup
After choosing an appropriate location within your home and safely
placing the Wine System, it is time to set up your
Wine System.
1. Before using the Wine System for the first time, it is
recommended that you rinse each of the Bottle Pour Assemblies.
They are fully submersible and can be washed by hand. (DO NOT
PUT IN DISHWASHER–NOT DISHWASHER SAFE.) Soap can
noticeably affect the flavors of fine wine, which is why most wine
connoisseurs simply give their glasses a hot water rinse. With this
in mind, it is possible, and recommended, to clean the Bottle Pour
Assembly with just a thorough hot water flush. Rinse until you see
water run clear. Dry with a soft cloth or
paper towel or allow it to air-dry.
2. To attach the glass doors to the unit:
• Carefully remove each glass door from its
protective packaging (being careful to
place on a soft padded surface so as not
to scratch the glass)
• Identify the (short) end of the glass door
that contains the “longer hinge pin” and
hold the door in a way that positions this
Figure A
pin to the upper left corner of the door.
Always grasp the door securely so as not
to drop it! (See Figure A)
• Carefully and fully insert the long hinge pin
(on the top of the door) up into the upper
hinge mount located on the front of the
Figure B
Wine System. (See Figure B)
Figure C
7
skybarhome.com