29.06.2015 Views

C2 - ClearStream 2 Antenna Assembly - Antennas Direct

C2 - ClearStream 2 Antenna Assembly - Antennas Direct

C2 - ClearStream 2 Antenna Assembly - Antennas Direct

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

1.<br />

<strong>C2</strong> - <strong>ClearStream</strong> 2<br />

<strong>Antenna</strong> <strong>Assembly</strong><br />

2.<br />

3.<br />

1. The <strong>ClearStream</strong> 2 antenna comes with:<br />

• 1 reflector<br />

• 1 set of tapered loop elements<br />

• 75 ohm transformer (internal)<br />

• 1 threaded bolt<br />

• 1 adjustable mast clamp<br />

2. Feed the supplied bolt through hole in U<br />

clamp assembly.<br />

4.<br />

3. Align the two halves of the separating column and attach<br />

the reflector (grid) to the antenna elements (Tapered loops)<br />

by threading the bolt through the center of the column.<br />

Tighten.<br />

4. <strong>Assembly</strong> complete. Attach the <strong>C2</strong><br />

antenna to any kind of mast or mount<br />

(up to 2” in diameter) with the adjustable U<br />

bolt clamp. The 75 ohm coax connector is<br />

in the center front.


11<br />

Performance<br />

5.<br />

5. <strong>ClearStream</strong> 2<br />

Gain and VSWR vs Frequency<br />

Gain is a measure of an antenna’s ability<br />

to concentrate radiated power from a<br />

particular direction. Unlike other antennas<br />

that claim high peak values, The gain<br />

of the <strong>C2</strong> is not only extremely high but<br />

nearly uniform across the DTV spectrum<br />

VSWR ( Voltage Standing Wave Ratio).<br />

The method used to compute losses from<br />

impedance mismatches. The lower the<br />

number the better. If the VSWR = 1 then<br />

there is no loss.<br />

dB<br />

10<br />

9<br />

8<br />

7<br />

6<br />

5<br />

4<br />

Core DTV spectrum 470 MHZ - 698 MHz<br />

Gain<br />

The efficiency of an antenna is how much<br />

signal received by the antenna actually<br />

makes it to the cable.<br />

The <strong>C2</strong> is an extremely efficient antenna.<br />

At its optimum frequency, the mismatch<br />

loss for the <strong>C2</strong> is very low - less than .1 dB.<br />

3<br />

VSWR<br />

2<br />

1<br />

400 MHz Ch 14 Ch 19<br />

Ch 27<br />

Ch 35<br />

Ch 43<br />

Ch 52 750 MHz<br />

6. <strong>ClearStream</strong> 2<br />

Horizontal Plane Reception<br />

Patterns<br />

6.<br />

The <strong>ClearStream</strong> 2 has very forgiving<br />

aiming characteristics with more than 70<br />

degrees of beamwidth across the main<br />

lobe as well as a powerful secondary<br />

rear lobe. This allows the <strong>C2</strong> to receive<br />

signals from multiple directions with a<br />

single fixed installation.<br />

Helpful Tips:<br />

• If your cable run is greater than 75’, A pre-amplifier may be required.<br />

• UHF signals are line of sight. Get as much elevation as practical.<br />

• Attic Installations will cut 40% -50% of your signal strength.<br />

• KEEP ANTENNA AWAY FROM POWER LINES<br />

877-825-5572<br />

1699 West Fifth Street<br />

Eureka, MO 63025<br />

www.antennasdirect.com

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!