supplier quality and packaging requirements manual - Commercial ...
supplier quality and packaging requirements manual - Commercial ...
supplier quality and packaging requirements manual - Commercial ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ATTACHMENT 13 – “387” Bunk Packaging Specification<br />
<br />
<br />
<br />
General Notes<br />
o Metric Dimensions are in parenthesis ( ).<br />
o Type of wood – Open.<br />
• Pallet should withst<strong>and</strong> typical h<strong>and</strong>ling.<br />
• Pallet should withst<strong>and</strong> the weight of 17 bunks.<br />
o Pallets shall conform to ISPM 15.<br />
Pallet Notes<br />
o Board to be void of the following defects:<br />
• Cracks greater than 6 inches (152mm) in board direction.<br />
• Cracks greater than 2 inches (51mm) in cross board direction.<br />
• Holes greater than 3 inches (72mm) in diameter.<br />
o The following dimensions are intended to be minimums:<br />
• 1.25 inches for the pallet board thickness.<br />
• Nail dimensions.<br />
Bunk Packaging Notes<br />
o Bunk stack to be 17 high.<br />
o Each bunk to be individually b<strong>and</strong>ed with three strips of cardboard, two on the ends <strong>and</strong> one in the<br />
middle.<br />
o Entire bunk stack to be b<strong>and</strong>ed three ways vertically, <strong>and</strong> two ways across the stack.<br />
o Every two bunks to be b<strong>and</strong>ed together for additional support.<br />
o B<strong>and</strong> strap to go underneath pallet, fastening bunks to pallet.<br />
o Entire bunk stack to be wrapped in corrugated board <strong>and</strong> shrink wrapped.<br />
o Open end of the bottom bunk is to face the skid.<br />
Cracks are where the woods split on the top<br />
surface. These should not be greater than 6”<br />
(152 mm) long.<br />
Wood<br />
pallet.<br />
Holes are voids that go all the way through<br />
the board. The hole should not be greater<br />
than 3” (76mm) wide in any direction.<br />
Cracks that go across the<br />
board should not be more<br />
than 2” in length.<br />
W.I. 7.4.3.1 Rev H Page 49 of 54<br />
Supplier Quality <strong>and</strong> Packaging Requirements Manual<br />
Printed Copies Uncontrolled