LCD Module User Manual

Recommendations

Info

7.Interface DescriptionPin No. Symbol Level Description1 V SS 0V Ground2 V DD 5.0V Power supply for Logic3 V O (Variable) Driving voltage for <strong>LCD</strong>4 RS H/L H:Data L :Instruction5 RW H/L H:Read L:Write6 E H/L Enable signal7~14 DB0~DB7 H/L Data bus. DB7 is used for Busy Flag .15 CS1 H Selection for IC1,active High16 CS2 H Selection for IC2,active High17 /RST L Reset signal, active low18 VEE -10V Negative voltage output19 A(LED+) +5.0V Anode of LED Backlight20 K(LED-) 0V Cathode of LED BacklightTG12864B-01XA0_A00 Page 6 of 14
8. Contour Drawing & Block DiagramTG12864B-01XA0_A00 Page 7 of 14
Page 1 and 2: LCD Module User ManualCustomer :Ord
Page 3 and 4: 1. Precautions in Use of LCD Module
Page 5: 6. Optical CharacteristicsITEM SYMB
Page 9 and 10: 10. Timing CharacteristicsCharacter
Page 11 and 12: 2) Set Address (Y Address)Y address
Page 13 and 14: 13. Display Data RAM mapTG12864B-01

LCD Module User Manual

Create successful ePaper yourself

Delete template?

Save as template?