Surfacing Agent MSDS - Fiberglass Supply

MATERIAL SAFETY DATA SHEETPAGE 485-X3SURFACING AGENT***********************************************************************necessary in any later manufacturing operations in which the productmay become. airborne in the form of vapor or dust.VENTILATIONUse ventilation as required to control vapor concentrations. Avoidprolonged or repeated breathing of vapors. If exposure exceeds TLV, usea NIOSH-approved respirator to prevent overexposure.Provide general dilution or local exhaust ventilation in volume andpattern to keep TLV of the most hazardous ingredient in Section IIbelow acceptable limit, LEL in Section XV below stated limit, and toremove decomposition products during welding or flame cutting onsurfaces coated with this product.HYGIENIC PRACTICESWASH HANDS THOROUGHLY BEFORE EATING AND USING WASHROOM.Remove contaminated clothing iir~nediate1y and do not wear it until ithas been properly laundered.DISCRETION ADVISEDLilly Industries, Inc. takes no responsibility for determining whatmeasures are required for personal protection in any specificapplication The general information given should be used withdiscretion.PROTECTIVE GLOVESRequired for prolonged or repeated contact. Wear resistant gloves suchas natural rubber, neoprene, buna N or nitrile. An apron should be wornto avoid skin contact.***********************************************************************SECTION IX SPECIAL PRECAUTIONS-----------------------------------------------------------------------HANDLING AND STORING PRECAUTIONSKeep product containers cool, dry, and away from sources of ignition.Use and store this product with adequate ventilation. Do NOT smoke instorage areas.Personnel should avoid inhalation of vapors. Personal contact with theproduct should be avoided. Should contact be made, remove saturatedclothing and flush affected skin areas with water. Containers of thismaterial may be hazardous when emptied. Since emptied containers retainproduct residues (vapor, liquid, and/or solid), all hazard precautionsgiven in this sheet must be observed.***********************************************************************SECTION X Section 313 Toxic Chemicals***********************************************************************This product contains the following toxic chemicals subject to thereporting requirements of section 313 of the Emergency Planning andCommunity Right-To-Know Act of 1986 and of 40 CFR 372. This informationmust be included in all MSDSs that are copied and distributed for thismaterial. (* Denotes percent parent metal contained in the precedingchemical compound)Fiberglass Supply, Inc. 314 West Depot P. O. Box 345 Bingen WA 98605-0345 USAPhone: (509) 493-3464 Fax: (509) 493-4053 E-mail: fiberglass@gorge.net Web Site: www.fiberglasssupply.com