10.07.2015 Views

ASSEMBLY AND OPERATION MANUAL - Hobbico

ASSEMBLY AND OPERATION MANUAL - Hobbico

ASSEMBLY AND OPERATION MANUAL - Hobbico

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

FINISHINGTHE EVADER EXT2TRANSMITTER PREPARATION• Slide the batttery tray door off and installeight “AA” batteries into transmitter,making sure the polarity is correct.BatteryTray Door+– + ––Battery Light+–+++–• Insert the antenna into the top of the transmitter and tighten.• Turn on the transmitter and check the battery light. If the red light glowssteadily, the batteries have enough voltage. If the red light blinks, thebatteries are low and should be replaced.RECEIVER ANTENNA INSTALLATION• Route the receiver antenna through the holes in thechassis as shown.• Thread the receiver antenna through the antenna tube.The antenna will be longer than the antenna tube.• Press fi t the antenna tube into the hole in the chassis.• Tip: Run the antenna wire through your fi ngers tostraighten out the kinks before running it through theantenna tube. Also, applying a small amount of soapand water to the antenna wire will help lubricate the wirefor threading into the antenna tube. Use a piece of tapeto hold the excess antenna wire to the antenna tube.DO NOT CUT THEX ANTENNA WIRE!4

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!