Garage/Workshop Heater

EWA SeriesCommercial Fan-Forced HeaterEngineered for outstanding performance anddependable service. Ideal for offices, reception areas,entrance ways, etc.Features• Built-in DPST thermostatwith on/off rocker switchesfor easier controlExclusive CastAluminumElement Design• Terminal block providedfor connection to optionalremote line voltagethermostat• Fan size and pitch arematched to the motor forsmooth, quiet operation• Exclusive rust free castaluminum heating gridprovides superiorperformance, stores energylonger by acting as a heatbank• Operates at a lowertemperature than any otherheating element on themarket• Built-in double polethermostatApplications• Offices, reception rooms,entranceways, stairwellsSpecificationsVoltageWattage120, 208, 240, 277VFive sizes ranging from 1000 to 4000WAirflow 50 CFM -1000, 1500, 2000W.100 CFM - 3000, 4000W.ColorFinishAlmondPolyester epoxy powder coat finish.Construction Units are fan type and utilize the “Down Flow“ principle of heated airdelivery. Designed for recessed mounting within standard 16” studcenters and wall thickness. Rugged 20 gauge steel construction.HeatingGridThe cast aluminum heating grid contains a nickel chromium resistancewire which is insulated in magnesium oxide and sheathed in aprotective tubular stainless steel sheath. The entire tube is completelycast into an aluminum molded form, deeply embedded and completelysafe. The finned design increases the heat radiating surface of the grid,giving wider distribution of heat at a safer, lower temperature than theheating element of any other wall heater.ControlsWarrantyA precision snap action hydraulic thermostat is included for positivetemperature control when the rocker switch is in the ON position. Thehydraulic capillary sensing element is located in the room air inlet airstream to provide accurate temperature. The thermostat ranges from40°F (low) to 100°F (high).One year on complete unit. UL and CSA approved.®24 | COMMERCIAL HEATERS TO ORDER PLEASE CALL 1-800-668-6663 OR FAX 1-800-668-6665