DESIGN AND FABRICATION OF DRAIN COVER BY CASTING ...

More documents

Recommendations

Info

9Figure 2.6Table below shows quick details of drain cover in figure 2.6Material: SteelBrand Name: LIHONGSteel material : ASTM A36 or Q235 Place of Origin: Zhejiang, ChinaSurface : Hot dip Galvanized or Self color CERTIFICATE : ISO9001-2000Drain system : trench grate, drain cover Place of Origin: Zhejiang China (Mainland)
10CHAPTER 3Methodology3.1 Project MethodologyThis chapter consists a review of the current design and other information about thecurrent design. These tasks have been done through research on the internet, books andother sources.3.2 Preliminary DesignAfter gathering all the relevant information, the project undergoes design inSolidWork. In this step, the information gathered from the review is used to make adesign. Before starting to the SolidWork design, the idea firstly is sketched in a piece ofpaper. All the idea generated is sketched and then is analyzed before moving toSolidWork design. The design is analyzed based on its suitability to be fabricated bysand casting process. After choosing the best design, the design then undergoes materialselection process. Then the sketch then is turned into SolidWork design. In this step, thedesign is drawn into 2D and 3D and put into dimension.
Page 3 and 4: viiTABLE OF CONTENTSCHAPTER TITLE P
Page 6: 1CHAPTER 1Introduction1.6 Backgroun
Page 9 and 10: 41.6 Grant chartFigure 1.2 shows th
Page 11 and 12: 6Normal types of drain cover are a
Page 13: 8Table below shows quick details of
Page 17 and 18: 123.3.1 Preliminary Concept DesignT
Page 19 and 20: 3.4 Finalize concept14
Page 21 and 22: 163.6 Pattern MakingTo proceed for
Page 23 and 24: 18i. Mold makingFirst step in sand
Page 25 and 26: 20ii.Clamping ProcessThe molten cas
Page 27 and 28: 22Figure 3.8: Removal processvi.Tri
Page 29: 24Figure 3.4 shows top view of the

DESIGN AND FABRICATION OF DRAIN COVER BY CASTING ...

Create successful ePaper yourself

Delete template?

Save as template?