DESIGN AND FABRICATION OF DRAIN COVER BY CASTING ...

More documents

Recommendations

Info

23CHAPTER 4Result and Discussion4.1 IntroductionThis chapter will present the solution method used to solved the problem statementand show all the design drawing by SolidWork with the actual product and shows theproblem faced during the casting process.4.2 ResultFigure 4.1: Drain Cover
24Figure 3.4 shows top view of the actual product of drain cover by castingprocess before trimming.Figure 4.2: Drain coverFigure 3.5 shows bottom view of the actual product of drain cover bycasting process before trimming.4.3 Solution Methodcover.To solve the problem statement, the following steps are taken and apply to the draini. Rusting- Spray protective layer to prevent from rustingii. Bad design- Sketch few design and select the best design by screening and scoringconcept.
Page 3 and 4: viiTABLE OF CONTENTSCHAPTER TITLE P
Page 6: 1CHAPTER 1Introduction1.6 Backgroun
Page 9 and 10: 41.6 Grant chartFigure 1.2 shows th
Page 11 and 12: 6Normal types of drain cover are a
Page 13 and 14: 8Table below shows quick details of
Page 15 and 16: 10CHAPTER 3Methodology3.1 Project M
Page 17 and 18: 123.3.1 Preliminary Concept DesignT
Page 19 and 20: 3.4 Finalize concept14
Page 21 and 22: 163.6 Pattern MakingTo proceed for
Page 23 and 24: 18i. Mold makingFirst step in sand
Page 25 and 26: 20ii.Clamping ProcessThe molten cas
Page 27: 22Figure 3.8: Removal processvi.Tri

DESIGN AND FABRICATION OF DRAIN COVER BY CASTING ...

Create successful ePaper yourself

Delete template?

Save as template?