TM 9-2320-272-24-4 - JATONKAM35s HOME ON THE WEB

TM 9-2320-272-24-45-7. CYLINDER LINERS AND BLOCK MAINTENANCETHIS TASK COVERS:a. Removal c. Cleaning and Inspectionb. Disassembly d. Cylinder Liners InstallationINITIAL SETUP:APPLICABLE MODELSM939/A1SPECIAL TOOLSLiner clamp set (Appendix E, Item 78)Liner driver (Appendix E, Item 79)TOOLSGeneral mechanic’s tool kit (Appendix E, Item 1)Cylinder liner puller (Appendix E, Item 107)Outside micrometer (Appendix E, Item 80)Vernier calipers (Appendix E, Item 159)Depth gauge (Appendix E, Item 81)Gauge block (Appendix E, Item 52)Dial indicator (Appendix E, Item 36)Telescoping gauge set (Appendix E, Item 136)Torque wrench (Appendix E, Item 144)Feeler gaugeHold-down toolMATERIAL PARTSTwo lockwashers (Appendix, Item 349)Suction flange gasket (Appendix D, Item 680)Two O-rings (Appendix D, Item 460)Crevice seal (Appendix D, Item 88)Drycleaning solvent (Appendix C, Item 71)Antiseize tape (Appendix C, Item 72)Lint-free cloth (Appendix C, Item 21)Lubricating oil OE/HDO (Appendix C, Item 50)Detergent (Appendix C, Item 27)REFERENCES (TM)TM 9-2320-272-24PEQUIPMENT CONDITIONCrankshaft and main bearings removed (para. 5-8).GENERAL SAFETY INSTRUCTIONSKeep fire extinguisher nearby when usingdrycleaning solvent.Drycleaning solvent is flammable and toxic. Donot use near an open flame.When cleaning with compressed air, weareyeshields and ensure source pressure does notexceed 30 psi (207 kPa).SPECIAL ENVIRONMENTAL CONDITIONSWork area clean and free from blowing dirt anddust.NOTETag all cylinder liners for installation.Remove six cylinder liners (1) from cylinder liner bores (2) with cylinder liner puller.5-34