TM 9-2320-272-24-4 - JATONKAM35s HOME ON THE WEB

TM 9-2320-272-24-4*This publication supersedes TM 9-2320-272-20-1,24 October 1985, and changes 1 through 4; TM 9-2320-272-20-2,25October 1985, and changes 1 through 3; TM 9-2320-272-34-1, 10 June 1986, and changes 1 through 2; TM 9-2320-272-34-2,10 June 1986, and changes 1 and 2; and TM 9-2320-358-24&P, 21 October 1992.This publication is published in four volumes. TM 9-2320-272-24-1 contains chapters 1,2, and 3 (throughsection IX). TM 9-2320-272-24-2 contains chapters 3 (sections X through XVI) and 4 (sections I through III).TM 9-2320-272-24-3 contains chapter 4 (sections IV through XVI). TM 9-2320-272-24-4 contains chapters 5 and6 and appendices A through H. Volume 1 contains a table of contents for the entire manual. Volumes 1,2, and 3contain an alphabetical index covering tasks found in their respective volume. Volume 4 contains analphabetical index covering all tasks found in the entire manual.TABLE OF CONTENTSCHAPTER 5Section I.Section II.Section III.Section IVSection VSection VI.Section VII.CHAPTER 6Section I.Section II.Section III.VOLUME 4 OF 4GENERAL SUPPORT (GS) MAINTENANCE INSTRUCTIONSPage............. 5-1Engine (M939/Al) Maintenance ............................................. 5-lEngine (M939A2) Maintenance .............................................. 5-157TransmissionMaintenance ................................................. 5-280Transfer Case Maintenance ................................................. 5-398Front and Rear Axle Maintenance ............................................ 5-432Special Purpose Bodies Maintenance ......................................... 5-463Winch, Hoist, and Power Takeoff (PTO) Maintenance ............................ 5-606SHIPMENT AND LIMITED STORAGE INSTRUCTIONS.................. 6-1General Preparation of Vehicle for Shipment ................................... 6-1Loading and Movement .................................................... 6-2LimitedStorage .......................................................... 6-2APPENDIX AREFERENCES..................................................... A-1APPENDIX BSection I.Section II.Section III.Section IV.APPENDIX CSection I.Section II.MAINTENANCE ALLOCATION CHART (MAC)......................... B-lIntroduction ............................................................. B-lMaintenance Allocation Chart (MAC) ......................................... B-4Tool and Test Equipment Requirements ....................................... B-25Remarks ................................................................ B-26EXPENDABLE/DURABLE SUPPLIES AND MATERIALS LIST............ C-1Introduction ............................................................. C-lExpendable/Durable Supplies and Materials List. ............................... C-3APPENDIX DMANDATORY REPLACEMENT PARTS................................ D-lAPPENDIX ECOMMON AND SPECIAL TOOL IDENTIFICATION LIST................ E-lAPPENDIX FILLUSTRATED LIST OF MANUFACTURED ITEMS..................... F-lAPPENDIX GTORQUE LIMITS................................................... G-lAPPENDIX HiiSCHEMATIC AND WIRING DIAGRAMS.............................. H-l