TT 33 00 22 55 BB GG MM - Paso Sound Products

Engineering DataSeries 30003 Channel-2 ZoneIntegrated Amplifierwith VOX - MOHDescription & ApplicationsThe *SERIES 3000 represents a modernengineering approach from conventionalaudio amplifiers in manufacturing, reliability,electro-mechanical integration, applied stateof the art technology and high performance.Packed with functional features and engineeredfor continuous duty, this new serieseasily adapts to Background Music Systems,Sound Reinforcement Systems, Paging-callSystems, Public Address, TelephoneInterconnect Systems and will withstand thegrueling demands normally found in industrialand commercial audio applications.The Amplifier features a 250 ohm balancedlow impedance microphone input switchableto a 600 ohm balanced input for paging interfacewith a Telephone line. Voice activatedelectronic precedence (VOX) over the AUXand Program channel (music muting) isstandard, and a 1 Watt MOH (Music on Hold)Amplifier is provided with balanced 600ohms and 8 ohms outputs. The 8 ohmOutput may be used to drive up to fourSpeakers as a separate Paging-free ZoneThe high reliability output stage is fully protectedagainst overloads and short circuitand provides a wide frequency responsewith very low distortion even at full poweroutput. The amplifier may be Rack mountedby using the optional Rack Mount Kit availableas an accessory (see accessories list).FeaturesLo Z Balanced Microphone InputInterface Ready for Telephone PagingVOX Voice Activated Music MutingMOH Music on Hold Balanced OutputIndependent Level Control for MOHBalanced Satellite Receiver InputAuxiliary InputSpecificationsPower Output:Distortion:Frequency Response:Sensitivity:Hum & Noise:Inputs:Telephone Input:Input Impedance:Music on Hold Output:Zone 2 Output:Output Impedance:Controls:Tone Control Action:Muting/Precedence:Power Requirement:Power Consumption:Terminations:Housing Finish:Dimensions:Net Weight:25 Watt RMSLess than 1% THD20 - 20,000 Hz ± 1 dbMic=1 Mv, Tel=100 Mv,Aux=200 Mv, Program=1 VoltMic -65 db, Aux -75 db1Mic/Tel, Aux, Program600 ohms interface readyMic= 250 ohms balanced, Tel= 600ohms balanced, Aux= 47 K ohms,Program= 10K ohms balanced1 Volt-600 ohms Balanced1 Watt-8 ohm8 ohms, 25 Volt and 70 Volt lineMic/Tel Volume, Aux/ProgramVolume Bass, Treble+/-10 db at 100 Hz and 10 K hzVoice Activated or Contact ClosureMic/Tel Precedence overAux/Program117 Volt, 50-60 Hz, 12VDC (4A)AC= 80 VA, DC= 48WScrew Terminals, RCA JackBlack10.5"W., 9.5"D., 3.5"H.(267X242X89 mm)12 Lbs (5.50 Kg)Features1 Watt, 8 ohm Independent Output AmplifierDirect Precedence MutingActive Separate Bass and Treble ControlsBuilt-in Overload ProtectionHigh Reliability OperationRack Mountable with Optional Rack Kit5 Year Unconditional WarrantyInnovation through technology since 1931T3025BGMT3025BGMREV 2.5© copyright Paso Sound Products, Inc. 1999 Specifications are subject to change without notice® MUZAK is a registered Trademark of MUZAK L. P.Form ED 211IC

TECHNICAL DATAT3025BGMCAUTION; TO REDUCE THE RISK OF FIRE OR SHOCK DONOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DONOT REMOVE COVER. THERE ARE NO USER SERVICEABLEPARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICEPERSONNEL. CAUTION: TO REDUCE THE RISK OFFIRE, REPLACE ONLY WITHSAMETYPE OF FUSE.ATTENTION: AFIN DE REDUIR LERISQUE D'INCENDIE, REMPLACERSEUL PAR UN FUSIBLE DE MEMETYPE.ATTENTION: POUR REDUIRLES RISQUESD' INCENDIE OU DE CHOC ELECTRIQUE,NE PAS EXPOSER A LA PLUIE OUL'HUMIDITE, NE PAS ENLEVER LECOUVERCLE. AUCUN REGLAGE AL'INTERIEUR. POUR REPARATIONCONSULTERUNE PERSONNE QUALIFIEE600 OHM1 VOLT8 OHM 25V-70VOUTPUT IMPEDANCESELECTORCOM8 OHM1 WATTMOH OUTPUT8 25V 70VMOH OUTPUT LEVELMIC250 OHM1 MvAMPLIFIERPOWER RATINGSUPPLY VOLTAGEPOWER CONSUMPTIONAUX 200 Mv47K ohmG COM HOT MUTE G COM HOTT3025BGM25 W RMS117V 60 HZ80 VATEL600 OHM100 MvGROUNDLINE FUSE1.6A 250 VCLASS 2 WIRING ACCEPTABLEPROGRAM10K OHM BALANCED1 VOLTMIC/TELBALANCEDRear Panel ViewMicrophone/Telephone InputThe amplifier is equipped with a Microphone input convertible to aTelephone line input by means of a slide switch on the rear panel.The microphone input impedance is 250 ohm balanced and theTelephone line input impedance is 600 ohm balanced. The inputlevel control for both models is provided on the front panel.Microphone or Telephone Paging with Auto-MutingThe Microphone or Telephone Paging input provides AutomaticVoice (VOX) activated Muting over the program (Music) input.Selection of the Microphone input mode (250 ohm balanced) orthe Telephone input mode (600 ohm balanced), is achieved by theuse of a slide switch located on the rear panel. Muting may be alsoaccomplished by direct contact closure of the Mute terminals.Desk Base MicrophonesA Desk Base Microphone with Precedence switch, such asthe Paso model B50X, may also be used. When the microphoneswitch is engaged the precedence (ProgramChannel Muting) is activated.Gooseneck MicrophoneA Push-To-Talk Gooseneck Microphone with Precedence switch,may be used. When the microphone switch is engaged the precedence(Program Channel Muting) is activated.Aux Input and Satellite Receiver Program InputTwo program inputs are provided, a 47 K ohm unbalanced input at200 Mv level (AUX) for Tuner or Tape and a 10 K ohm balancedinput at 1 Volt level (PROGRAM). The high level balanced Programinput is ideal for use with Satellite Receivers or a Satellite ReceiverNetworks. Both inputs are muted when Paging from theMicrophone/Telephone input or by contact closure of the Mute terminals.600 ohm Balanced MOH OutputAn independent 1 Volt-600 ohm balanced.Output is provided forMusic on Hold Applications. The MOH Amplifier uses as a sourcethe Aux or the Program input only (not the Mic source) and it is notmuted by the Vox or by the direct muting circuit.Zone 2 - Independent 1 Watt - 8 ohm AmplifierA 1 Watt-8 ohm Amplifier with level control is provided for Music onHold applications or for Speaker(s) use without Paging (Musicsource same as for the MOH). Up to 4 (8 ohm) Speakers may beconnected to this output.Accessories27/3500 - Standard 19" Rack Mounting Kit. Complete with hardware.Black Finish. Occupies two units of rack vertical space.27/3503 - Wall Mounting Kit. Allows the amplifier to be wall mountedor mounted on a convenient surface. Black Finish.Architects’ and Engineers’ SpecificationsThe integrated amplifier shall be a solid state voltage and power amplifier operating on AC or DC power. The power output shall be 25 watt RMS. The frequency response shallbe 20 to 20,000 Hz +/- 3 db. One switchable microphone/telephone input and two program inputs shall be provided. The amplifier shall be interface ready for paging from aTelephone line. An independent 1 Watt Amplifier for Music on Hold or Speaker shall be provided. The MOH output impedance shall be 1 Watt-8 ohm and 1 Volt-600 ohm balanced.The microphone input impedance shall be 250 ohm balanced. The Telephone input impedance shall be 600 ohm balanced. The auxiliary input impedance shall be 47K ohm and the Program input shall be10 K ohm balanced. Electronic microphone/telephone precedence over the auxiliary and program channel shall be voice activated or byexternal contact closure. The output shall be 8 ohm and 25 Volt and 70.7 Volt lines. A Microphone/Telephone and a Program/Auxiliary inputs volume controls shall be provided.Independent Bass and Treble controls shall also be provided. The amplifier shall operate on 117 Volts 60 Hz . Dimensions shall be 10.5" Wide, 9.5" Deep, 3.5" High(267X242X89 mm). The net weight shall be 12 lb. (5.50 Kg). Finish shall be black. The amplifier shall be rack mountable by using the optional rack mounting kit. The Paso modelT3025BGM is specified.since 1931AUTHORIZED DISTRIBUTORPASO SOUND PRODUCTS, INC.4750F GOER DRIVENORTH CHARLESTON, SC 29406 USAPhone: 843 308 9005 - Fax: 843 308 0904EMAIL: info@pasosound.com - URL: www.pasosound.comFORM ED 211 RV 2.5 Printed in USA