NetTEST II PROFIBUS Analysis Tool - FT AutomaÃ§Ã£o

More documents

Recommendations

Info

FT AUTOMAÇÃO INDUSTRIAL LTDASimple & quick adaptationto the DP segment subject of measurement• PROFIBUS address• System Baud rate• Slot time• Number of 12 MBit plugs used• Number of devices connected to the bus
FT AUTOMAÇÃO INDUSTRIAL LTDAUseful information for physical measurements• Only active stations (masters) have to be disconnected from the bus,slaves may stay connected.• The physical measurement of the PROFIBUS line is only carriedout within electrical segments, without including repeaters.• The minimum length of line to be measured is 10 m. The shorterthe line lengths, the more inexactly the measurement may become.• NetTEST II is designed for standard PROFIBUS-Cable type A(150 Ohm surge impedance, core cross section >0,34 mm²).Different types of cables, e.g. obsolete cable type B(100 Ohm surge impedance) are not to be used and arerecognized as faulty by NetTEST II.Start
Page 1: NetTEST IIPROFIBUS Analysis ToolPro
Page 5 and 6: FT AUTOMAÇÃO INDUSTRIAL LTDANetTE
Page 7 and 8: FT AUTOMAÇÃO INDUSTRIAL LTDANetTE
Page 9 and 10: NetTEST II Measurement report******
Page 11 and 12: A typical Profibus-DPDP-RS485segmen
Page 13: Performing a 3-3stage testFT AUTOMA
Page 17 and 18: NetTEST II - Trouble-free &comforta
Page 19 and 20: NetTEST II with Online Functionup t
Page 21 and 22: Measurements with PLCFT AUTOMAÇÃO
Page 23 and 24: Generating a Live ListFT AUTOMAÇÃ
Page 25 and 26: Level measurementFT AUTOMAÇÃO IND
Page 27 and 28: Event log• NetTEST II analyses th
Page 29 and 30: Diagnostic eventFT AUTOMAÇÃO INDU

NetTEST II PROFIBUS Analysis Tool - FT AutomaÃ§Ã£o

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?