Cisco WAP200 Wireless-G Access Point with PoE and ...

More documents

Recommendations

Info

Wireless-G Access Point with Power Over Ethernet and RangeboosterWireless Bridge. This mode connects physically separated wired networks using multiple access points.Wireless clients will not be able to connect to the access point in this mode. Enter the MAC address(es) of theaccess point(s) that will bridge to this access point.IMPORTANT: In Wireless Bridge mode, the Access Point can ONLY be accessed by another accesspoint set to Wireless Bridge mode. In order for your other wireless devices to connect to theAccess Point, you must reset it to Access Point mode. The two modes are mutually exclusive.Wired LANSwitchAccess Point(WirelessBridge Mode)Access Point(WirelessBridge Mode)SwitchWired LANWAP200 (Wireless Bridge mode)Wired LANSwitchAccess Point(WirelessBridge Mode)Access Point(WirelessBridge Mode)SwitchWired LANFigure 6-19: Wireless Bridge ModeChapter 6: Configuring the Wireless-G Access PointThe AP Mode Tab30
Wireless-G Access Point with Power Over Ethernet and RangeboosterThe Security Monitor - Basic Settings TabOn this screen you can enable or disable the security monitor feature of this Wireless Access Point. It also allowsyou to create user accounts for system administrators to use this advanced feature.This feature works together with Linksys Business Series wireless client adapters. A client utility will be providedwith the client card, which will allow you to download information from the Access Point. The current version willsupport wireless Access Points and wireless clients detection and classification. Please check Linksys.com forfuture updates on this powerful security feature.Wireless Security MonitorEnabled/Disabled. You can enable or disable the security monitor feature here. When it is enabled, the AccessPoint will work with selected wireless PCs to monitor your wireless network. If you don’t plan to use the clientutility to actively monitor your network, you can disable this feature to improve your wireless networkperformance. The default is Disabled.Figure 6-20: Security Monitor - Basic SettingsSecurity Monitor AccountsThe section allows the system administrator to create accounts for the purpose of wireless security monitoring.You can create one account at a time. The administrator will be able to use his client utility to log in and getauthenticated to the system after user accounts are created.User Name. Enter the user name of this account.Password. Enter the password of this account.Re-enter to confirm. Enter the password a second time to re-confirm it.Identify. You can create either an Administrator or User account by making the selection here. You can create oneAdministrator account and five User accounts.Click the Add/Save button to create an account. The accounts that are created will display in the table.Change these settings as described here and click Save Settings to apply your changes, or click CancelChanges to cancel your changes. Help information is available on the right side of the screen.Chapter 6: Configuring the Wireless-G Access PointThe Security Monitor - Basic Settings Tab31
Page 1 and 2: Wireless-G Access Pointwith Power O
Page 3 and 4: Wireless-G Access Point with Power
Page 35: Wireless-G Access Point with Power

Cisco WAP200 Wireless-G Access Point with PoE and ...

Create successful ePaper yourself

Delete template?

Save as template?