PCI-CTR05 User's Guide

More documents

Recommendations

Info

Installing the PCI-CTR05Chapter 2What comes with your PCI-CTR05 shipment?As you unpack your board, make sure that the following components are included.Hardware• PCI-CTR05SoftwareThe Measurement Computing Data Acquisition Software CD contains the following software:• InstaCal installation, calibration, and test utility• TracerDAQ suite of virtual instruments• SoftWIRE for VS .NET (evaluation version)DocumentationIn addition to this hardware user's guide, you should also receive the Quick Start Guide (available in PDFat www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf). Please read this booklet completelybefore installing any software and hardware.2-1
PCI-CTR05 User's GuideInstalling the PCI-CTR05Optional componentsIf you ordered any of the following products with your board, they should be included with yourshipment.CablesC37FF-xC37FFS-xSignal termination and conditioning accessoriesMCC provides signal termination and signal conditioning products for use with the PCI-CTR05. Refer toField wiring, signal termination and conditioning for a complete list of compatible accessory products.Unpacking the boardThe PCI-CTR05 board is shipped in an antistatic container to prevent damage by an electrostaticdischarge. To avoid such damage, perform the following procedure when unpacking and handling yourboard:1.2.3.Before opening the antistatic container, ground yourself with a wrist-grounding strap or by holdingonto a grounded object (such as the computer chassis).Touch the antistatic container to the computer chassis before removing the board from the container.Remove the board from the container. Never touch the exposed pins or circuit connections on theboard.If your board is damaged, notify Measurement Computing Corporation immediately by phone, fax, ore-mail. For international customers, contact your local distributor where you purchased the PCI-CTR05.• Phone: 508-946-5100 and follow the instructions for reaching Tech Support.• Fax: 508-946-9500 to the attention of Tech Support• Email: techsupport@measurementcomputing.comInstalling the softwareInstall the software included with your board before you install the hardware. Installing the software firstensures that the information required for proper board detection is installed and available at boot up.Refer to the Quick Start Guide for instructions on installing the software on the Measurement ComputingData Acquisition Software CD. This booklet is available in PDF atwww.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf.2-2
Page 2 and 3: PCI-CTR059513-Based Counter/TimerUs
Page 4 and 5: Trademark and Copyright Information
Page 6: About this User's GuidePrefaceWhat
Page 9: PCI-CTR05 User's GuideIntroducing t
Page 13 and 14: PCI-CTR05 User's GuideInstalling th
Page 15 and 16: Programming and software applicatio
Page 17 and 18: PCI-CTR05 User's GuideSpecification
Page 19 and 20: PCI-CTR05 User's GuideSpecification
Page 21: Measurement Computing Corporation16

PCI-CTR05 User's Guide

Create successful ePaper yourself

Delete template?

Save as template?