XTS-100C - Comtech Xicom Technology

XTS-100CC-Band OutdoorSolid State Power Amplifiers• 100 Watt• No Shelter Required• Short Waveguide Run• Low Cost Installation• Removable Power Supply• Complete Digital M&C Interface• RS-232, RS-422, RS-485• Built-in Redundancy Control1:11:1 with load switching1+1 Soft FailThe XTS-100C high power solid state poweramplifier are compact, fully integrated antennamountunits designed for low cost operation andlongevity.Intended for outdoor operation, the XTS-100Celiminate the need for a separate amplifier shelter.In addition, the distance between the amplifierand the antenna feed can be shorter, thuseliminating long waveguide runs and associatedRF losses.RF Filters, cooling, and monitor and control(M&C) systems are all self-contained within thepackage.A high frequency resonant conversion powersupply is used that accepts a wide range ofprime power (90 to 264 VAC).A remote external controller is available tooperate the SSPA from a user-selected location.Depending upon user requirements, these highpower amplifiers can be configured for singlethread, redundant, or phase combined configurations.Mounting brackets are supplied to mount thehigh power amplifier to most popular antennas.Field Replaceable Power Supply3550 Bassett Street •Santa Clara, CA •95054Tel: (408) 213-3000 •Fax: (408) 213-3001www.xicomtech.com

PERFORMANCE SPECIFICATIONSParameterFREQUENCY RANGE standardother frequency coverage availableXTS-100C5.85-6.425 GHz 5.85-6.65 GHz(Option C1)OUTPUT POWERSaturated Power (Typical)Rated Power(P1dB) @ Amplifier FlangeGAINSmall Signal, minimumSmall Signal, maximumGain Flatness, maximumMaximum SSG Variation Over:Slope, maximumStability, 24 Hr maximumStability, Temperature50 dBm49 dBm50 dBm49 dBm65 dB, gain control set for maximum gain75 dB, gain control set for maximum gain2.5 dB0.8 dB per 40 MHz± 0.04 dB/MHz± 0.25 dB± 2.0 dB maximum over temperature range at any frequencyGAIN CONTROL20 dBINTERMODULATIONwith two equal signals- 25 dBc maximum with two equal carriers at3 dB total power backoff from rated outputHARMONIC OUTPUT, maximum- 60 dBcAM/PM CONVERSION, maximum2.5 deg/dB at 3 dB below rated output powerNOISE POWER, maximumTransmit BandReceive Band- 80 dBW/4 kHz- 150 dBW/4 kHz3.7 to 4.2 GHzGROUP DELAY, maximumBandwidthLinearParabolicRippleAny 40 MHz± 0.03 nS/MHz± 0.003 nS/MHz 21 nS/Pk-PkRESIDUAL AM NOISE, maximum- 50 dBc to 10 kHz- 20 (1.5 + logf) dBc 10 to 500 kHz- 85 dBc above 500 kHzPHASE NOISE, maximum10 dB below IESS phase noise profileVSWRInput, maximumOutput, maximum1.2:11.3:1XTS-100C

PRIME POWEROPTIONSWorking Range 90 MIN. - 264 MAX., VAC • Extended Frequency47 to 63 Hz, single phase650 VA Typical0.95 Minimum Prime Power Factor5.85-6.65 GHz C15.85-6.725 GHz C2• Built-in L-Band Block Upconverter Option B1Frequencies Available:5.85-6.425 GHz5.85-6.65 GHzENVIRONMENTNONOPERATING TEMPERATURE RANGEOPERATING TEMPERATURE RANGEHUMIDITYALTITUDESHOCK AND VIBRATIONCOOLING-50° C to + 70° C-40° C to +50° C, 2°C/1000 feet deratingUp to 100% Condensing12,000 feet MSL maximumNormal TransportationForced AirINTERFACETYPEFUNCTIONLOCAL CONTROL Prime Power ON/OFF Local/RemoteLOCAL STATUSPower Supply ON/OFFTri-Color LED:Fault: RedTransmit ON: GreenTransmit ON/OFFStandby: AmberREMOTE CONTROL Transmit ON/OFF RF InhibitRF AttenuationSummary FaultFault ResetConstant PowerREMOTE STATUS Transmit ON Transmit/Standby HoursRF Output PowerReflected PowerFault IdentificationTemperatureForm C Dry Contact ClosureSummary FaultXicom Command Set ASCII CommandsRF MONITOR PORT-40 dB Coupling Value (Nominal)XTS-100C High PowerSolid State Amplifiers

Block DiagramOutline DrawingDocument # 805-1601-001 07/22/2008XTS-100C REV 9© 2008Note: Technical specifications are subject to changewithout notice. Please contact Xicom Technology beforeusing this information for system design.3550 Bassett Street •Santa Clara, CA •95054Tel: (408) 213-3000 •Fax: (408) 213-3001www.xicomtech.com